Reference only
Caution
4. Type of Applied Voltage and Self-heating Temperature
1. Confirm the operating conditions to make sure that no large current is flowing into the capacitor due to the continuous
application of an AC voltage or pulse voltage. When a DC rated voltage product is used in an AC voltage circuit or a
pulse voltage circuit, the AC current or pulse current will flow into the capacitor; therefore check the self-heating condition.
Please confirm the surface temperature of the capacitor so that the temperature remains within the upper limits of the
operating temperature, including the rise in temperature due to self-heating. When the capacitor is used with a
high-frequency voltage or pulse voltage, heat may be generated by dielectric loss.
<Applicable to Temperature Characteristics C0G(5C)>
Since the self-heating is low in the low loss series, the allowable voltage becomes extremely high compared to
the common X7R(R7) characteristics. However, when a load with self-heating of 20°C is applied at the rated voltage, the
allowable voltage may be exceeded. When the capacitor is used in a high-frequency voltage circuit of 1kHz or more, the
frequency of the applied voltage should be less than 1MHz sine wave to limit the voltage load so that the load remains
within the derating load so that the load remains within the derating shown in the following figure. In the case of non-sine
wave, high-frequency components exceeding the fundamental frequency may be included. In such a case, please contact us.
[Sine-wave frequency VS allowable voltage]
The surface temperature of the capacitor (including self-heating):105℃
Rated Voltage:DC1000V
Rated Voltage:DC630V
5. DC Voltage and AC Voltage Characteristics
1. The capacitance value of a high dielectric constant type capacitor changes depending on the DC voltage applied.
Please consider the DC voltage characteristics when a capacitor is selected for use in a DC circuit.
1-1. The capacitance of ceramic capacitors may change sharply depending on the applied voltage (see figure).
Please confirm the following in order to secure the capacitance.
(1) Determine whether the capacitance change caused by the applied voltage is within the allowed range.
(2) In the DC voltage characteristics, the rate of capacitance change becomes larger as voltage increases, even if the
applied voltage is below the rated voltage. When a high dielectric constant type capacitor is used in a circuit that
requires a tight (narrow) capacitance tolerance (e.g., a time constant circuit), please carefully consider the voltage
characteristics, and confirm the various characteristics in actual operating conditions in an actual system.
2. The capacitance values of high dielectric constant type capacitors changes depending on the AC voltage applied.
Please consider the AC voltage characteristics when selecting a capacitor to be used in an AC circuit.
6. Capacitance Aging
1. The high dielectric constant type capacitors have the characteristic in which the capacitance value decreases with the
passage of time. When you use high dielectric constant type capacitors in a circuit that needs a tight (narrow) capacitance
tolerance (e.g., a time-constant circuit), please carefully consider the characteristics of these capacitors, such as their
aging, voltage, and temperature characteristics. In addition, check capacitors using your actual appliances at the intended
environment and operating conditions.
7. Vibration and Shock
1. Please confirm the kind of vibration and/or shock, its condition, and any
and any generation of resonance. Please mount the capacitor so as not to
generate resonance, and do not allow any impact on the terminals.
Crack
Floor
2. Mechanical shock due to being dropped may cause damage or
a crack in the dielectric material of the capacitor.
Do not use a dropped capacitor because the quality and reliability may be deteriorated.
3. When printed circuit boards are piled up or handled,
the corner of another printed circuit board should not be allowed
to hit the capacitor, in order to avoid a crack or other damage to the capacitor.
2/19
EGKRC03C