5秒后页面跳转
ISL6144IRZAT PDF预览

ISL6144IRZAT

更新时间: 2024-01-11 02:55:18
品牌 Logo 应用领域
瑞萨 - RENESAS 驱动接口集成电路驱动器
页数 文件大小 规格书
30页 1179K
描述
IC 2 A BUF OR INV BASED MOSFET DRIVER, PQCC16, ROHS COMPLIANT, 5 X 5 MM, PLASTIC, MO-220VHHC, QFN-16, MOSFET Driver

ISL6144IRZAT 技术参数

是否无铅:不含铅是否Rohs认证:符合
生命周期:Active零件包装代码:QFN
包装说明:ROHS COMPLIANT, 5 X 5 MM, PLASTIC, MO-220VHHC, QFN-16针数:16
Reach Compliance Code:compliant风险等级:5.2
Is Samacsys:N高边驱动器:YES
接口集成电路类型:BUFFER OR INVERTER BASED MOSFET DRIVERJESD-30 代码:S-PQCC-N16
JESD-609代码:e3长度:5 mm
湿度敏感等级:3功能数量:1
端子数量:16最高工作温度:105 °C
最低工作温度:-40 °C标称输出峰值电流:2 A
封装主体材料:PLASTIC/EPOXY封装代码:HVQCCN
封装形状:SQUARE封装形式:CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE
峰值回流温度(摄氏度):260认证状态:Not Qualified
座面最大高度:1 mm最大供电电压:75 V
最小供电电压:10 V标称供电电压:48 V
表面贴装:YES温度等级:INDUSTRIAL
端子面层:MATTE TIN端子形式:NO LEAD
端子节距:0.8 mm端子位置:QUAD
处于峰值回流温度下的最长时间:40断开时间:0.3 µs
宽度:5 mmBase Number Matches:1

ISL6144IRZAT 数据手册

 浏览型号ISL6144IRZAT的Datasheet PDF文件第2页浏览型号ISL6144IRZAT的Datasheet PDF文件第3页浏览型号ISL6144IRZAT的Datasheet PDF文件第4页浏览型号ISL6144IRZAT的Datasheet PDF文件第5页浏览型号ISL6144IRZAT的Datasheet PDF文件第6页浏览型号ISL6144IRZAT的Datasheet PDF文件第7页 
ISL6144  
Data Sheet  
October 6, 2011  
FN9131.7  
High Voltage ORing MOSFET Controller  
Features  
The ISL6144 ORing MOSFET Controller and a suitably sized  
N-Channel power MOSFET(s) increases power distribution  
efficiency and availability when replacing a power ORing diode  
in high current applications.  
• Wide Supply Voltage Range +9V to +75V  
• Transient Rating to +100V  
• Reverse Current Fault Isolation  
• Internal Charge Pump Allows the use of N-Channel  
MOSFET  
In a multiple supply, fault tolerant, redundant power distribution  
system, paralleled similar power supplies contribute equally to  
the load current through various power sharing schemes.  
Regardless of the scheme, a common design practice is to  
include discrete ORing power diodes to protect against reverse  
current flow should one of the power supplies develop a  
catastrophic output short to ground. In addition, reverse current  
can occur if the current sharing scheme fails and an individual  
power supply voltage falls significantly below the others.  
• HS Comparator Provides Very Fast <0.3µs Response  
Time to Dead Shorts on Sourcing Supply. HS Comparator  
also has Resistor-adjustable Trip Level  
• HR Amplifier allows Quiet, <100µs MOSFET Turn-off for  
Power Supply Slow Shut Down  
• Open Drain, Active Low Fault Output with 120µs Delay  
• Provided in Packages Compliant to UL60950 (UL1950)  
Creepage Requirements  
Although the discrete ORing diode solution has been used for  
some time and is inexpensive to implement, it has some  
drawbacks. The primary downside is the increased power  
dissipation loss in the ORing diodes as power requirements for  
systems increase. Another disadvantage when using an ORing  
diode would be failure to detect a shorted or open ORing diode,  
jeopardizing power system reliability. An open diode reduces  
the system to single point of failure while a diode short might  
pose a hazard to technical personnel servicing the system  
while unaware of this failure.  
• QFN Package:  
- Compliant to JEDEC PUB95 MO-220  
QFN - Quad Flat No Leads - Package Outline  
- Near Chip Scale Package footprint, which improves  
PCB efficiency and has a thinner profile  
• Pb-Free (RoHS Compliant)  
Applications  
The ISL6144 can be used in 9V to 75V systems having similar  
power sources and has an internal charge pump to provide a  
floating gate drive for the N-Channel ORing MOSFET. The High  
Speed (HS) Comparator protects the common bus from  
individual power supply shorts by turning off the shorted feed’s  
ORing MOSFET in less than 300ns and ensuring low reverse  
current.  
• ORing MOSFET Control in Power Distribution Systems  
• N + 1 Redundant Distributed Power Systems  
• File and Network Servers (12V and 48V)  
Telecom/Datacom Systems  
An external resistor-programmable detection level for the HS  
Comparator allows users to set the N-Channel MOSFET  
“V  
- V ” trip point to adjust control sensitivity to power  
OUT  
IN  
supply noise.  
The Hysteretic Regulating (HR) Amplifier provides a slow turn-  
off of the ORing MOSFET. This turn-off is achieved in less than  
100μs when one of the sourcing power supplies is shutdown  
slowly for system diagnostics, ensuring zero reverse current.  
This slow turn-off mechanism also reacts to output voltage  
droop, degradation, or power-down.  
An open drain FAULT pin will indicate that a fault has occurred.  
The fault detection circuitry covers different types of failures;  
including dead short in the sourcing supply, a short of any two  
ORing MOSFET terminals, or a blown fuse in the power  
distribution path.  
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.  
1
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.  
Copyright © Intersil Americas Inc. 2004, 2006-2011. All Rights Reserved  
All other trademarks mentioned are the property of their respective owners.  

与ISL6144IRZAT相关器件

型号 品牌 描述 获取价格 数据表
ISL6144IRZA-T RENESAS High Voltage ORing MOSFET Controller; QFN20, TSSOP16; Temp Range: -40&deg; to 85&d

获取价格

ISL6144IRZA-T13 RENESAS Buffer/Inverter Based MOSFET Driver

获取价格

ISL6144IRZA-T7 RENESAS Buffer/Inverter Based MOSFET Driver

获取价格

ISL6144IV INTERSIL High Voltage ORing MOSFET Controller

获取价格

ISL6144IV RENESAS 2A BUF OR INV BASED MOSFET DRIVER, PDSO16, PLASTIC, MO-153AB, TSSOP-16

获取价格

ISL6144IV-T RENESAS 2A BUF OR INV BASED MOSFET DRIVER, PDSO16, PLASTIC, MO-153AB, TSSOP-16

获取价格