HV7022-C
34-Channel Symmetric Row Driver
Ordering Information
Package Options
44 J-Lead Quad
Device
44 J-Lead Quad
Die in
waffle pack
44 J-Lead Quad
Ceramic Chip Carrier
(MIL-Std-883 Processed*)
Ceramic Chip Carrier
Plastic Chip Carrier
HV7022-C
HV7022DJ-C
HV7022PJ-C
HV7022X-C
RBHV7022DJ-C
*For Hi-Rel process flows, refer to page 5-3 of the databook.
Features
General Description
❏
Processed with HVCMOS® technology
The HV7022-C is a low-voltage serial to high-voltage parallel
converter with push-pull outputs. It is especially suited for use as
asymmetricrowdriverinACthin-filmelectroluminescent(ACTFEL)
displays. The HV70 offers 34 output lines, a direction (DIR) pin to
give CW or CCW shift register loading, output enable (OE), and
polarity(POL)control.AfterDATAINPUTisentered(onthefalling
edge of CLOCK), a logic high will cause the output to swing to VPP
if POL is high, or to GND if POL is low.
❏
Symmetric row drive (reduces latent imaging
in ACTFEL displays)
❏
❏
❏
❏
❏
❏
❏
Output voltages up to 230V
Low-power level shifting
Source/Sink current 70mA (min.)
Shift register speed 4MHz
Pin-programmable shift direction
44-lead plastic & ceramic surface-mount packages
Hi-Rel processing available
Absolute Maximum Ratings
1
Supply voltage, VDD
-0.3V to +15V
1
Supply voltage, VPP
Logic input levels1
Ground current2
-0.3V to +250V
-0.3V to VDD +0.3V
1.5A
Continuous total power dissipation3: Plastic
Ceramic
1200mW
1500mW
Operating temperature range
Plastic
Ceramic
-40°C to +85°C
-55°C to 125°C
Storage temperature range
-65°C to +150°C
260°C
Lead temperature 1.6mm (1/16 inch)
from case for 10 seconds
Notes:
1. All voltages are referenced to GND.
2. Duty cycle is limited by the total power dissipated in the package.
3. For operation above 25°C ambient derate linearly to maximum operating
temperature at 25mW/°C for plastic and at 15mW/°C for ceramic.
For Detailed circuit and application information, please refer
to Application Note AN-H3.
02/96/022
Supertex Inc. does not recommend the use of its products in life support applications and will not knowingly sell its products for use in such applications unless it receives an adequate "products liability
indemnification insurance agreement." Supertex does not assume responsibility for use of devices described and limits its liability to the replacement of devices determined to be defective due to
workmanship. No responsibility is assumed for possible omissions or inaccuracies. Circuitry and specifications are subject to change without notice. For the latest product specifications, refer to the
Supertex website: http://www.supertex.com. For complete liability information on all Supertex products, refer to the most current databook or to the Legal/Disclaimer page on the Supertex website.
1