AMD PCnetä -Home Software Release 1.03
User Interface
HOMELANDIAG comes with a simple user interface that consists of a main control program,
called HOMEDIAG, that is launched from the MS-DOS command line. HOMEDIAG contains a
sequence of calls to the diagnostic module, ND_MAIN.EXE, where the individual tests are
launched.
When the user is prompted to enter a choice - if the user types in an invalid choice, it is ignored
and no action is taken.
Log File Creation
If the '/log' option is used 2 files are created namely -
HOMELANDIAG.LOG
This file contains the PCI-scan information and also the test
results is not very detailed form.
ND_MAIN.LOG
This file contains detailed information (which can be enabled via
setting DOS environment variables as described below.
/****************************************************************************
check_debug_flags - Check for debug flags in DOS environment variables.
Debug use only:
netdiag - Log: Show the settings of the debug variables below.
dump1 - Log: Show Command Block Arguments.
dump2 - Log: Show Globals, Show CSRs.
dump3 - Log: Show IB, Show Rings, Show Tx/Rx Buffers.
dump4 - Log: Trace information for low level functions.
dump5 -
dump6 - Log: Test 4, Show data path configuration.
dump7 - Log: If dump3 enabled, Show full contents of Rx buffers.
dump8 - Log: SRAM access details.
dump9 - Log: Flash access details.
dump10 -
debug1 - Log: Disable low level HW I/O to controller (BCRs, etc.).
debug2 - Enable wake up of the Turbo Debugger.
debug3 - PRETEND AMD Flash detected: AM29F010.
debug4 - PRETEND SRAM detected: xxxx pages.
****************************************************************************/
6
PCnetä -Home Evaluation Kit