5秒后页面跳转
HIP6302 PDF预览

HIP6302

更新时间: 2024-01-07 13:35:31
品牌 Logo 应用领域
英特矽尔 - INTERSIL 调节器微处理器多相元件控制器
页数 文件大小 规格书
17页 186K
描述
Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller

HIP6302 技术参数

是否Rohs认证:符合生命周期:Obsolete
零件包装代码:SOIC包装说明:SOIC-16
针数:16Reach Compliance Code:compliant
ECCN代码:EAR99HTS代码:8542.39.00.01
风险等级:5.19Is Samacsys:N
模拟集成电路 - 其他类型:SWITCHING CONTROLLER控制模式:CURRENT/VOLTAGE-MODE
控制技术:PULSE WIDTH MODULATION最大输入电压:5.25 V
最小输入电压:4.75 V标称输入电压:5 V
JESD-30 代码:R-PDSO-G16JESD-609代码:e3
长度:9.9 mm湿度敏感等级:3
功能数量:1端子数量:16
最高工作温度:70 °C最低工作温度:
封装主体材料:PLASTIC/EPOXY封装代码:SOP
封装等效代码:SOP16,.25封装形状:RECTANGULAR
封装形式:SMALL OUTLINE峰值回流温度(摄氏度):260
认证状态:Not Qualified座面最大高度:1.75 mm
子类别:Switching Regulator or Controllers表面贴装:YES
切换器配置:PHASE-SHIFT最大切换频率:1500 kHz
温度等级:COMMERCIAL端子面层:Matte Tin (Sn) - annealed
端子形式:GULL WING端子节距:1.27 mm
端子位置:DUAL处于峰值回流温度下的最长时间:40
宽度:3.9 mmBase Number Matches:1

HIP6302 数据手册

 浏览型号HIP6302的Datasheet PDF文件第2页浏览型号HIP6302的Datasheet PDF文件第3页浏览型号HIP6302的Datasheet PDF文件第4页浏览型号HIP6302的Datasheet PDF文件第5页浏览型号HIP6302的Datasheet PDF文件第6页浏览型号HIP6302的Datasheet PDF文件第7页 
HIP6302  
Data Sheet  
February 2000  
File Number 4766  
Microprocessor CORE Voltage Regulator  
Multi-Phase Buck PWM Controller  
Features  
• Multi-Phase Power Conversion  
The HIP6302 multi-phase PWM control IC together with its  
companion gate drivers, the HIP6601, HIP6602 or HIP6603  
and Intersil MOSFETs provides a precision voltage  
regulation system for advanced microprocessors.  
Multiphase power conversion is a marked departure from  
earlier single phase converter configurations previously  
employed to satisfy the ever increasing current demands of  
modern microprocessors. Multi-phase convertors, by  
distributing the power and load current results in smaller and  
lower cost transistors with fewer input and output capacitors.  
These reductions accrue from the higher effective  
conversion frequency with higher frequency ripple current  
due to the phase interleaving process of this topology. For  
example, a two phase convertor operating at 350kHz will  
have a ripple frequency of 700kHz. Moreover, greater  
convertor bandwidth of this design results in faster response  
to load transients.  
• Precision Channel Current Sharing  
- Loss Less Current Sampling - Uses r  
DS(ON)  
• Precision CORE Voltage Regulation  
- ±1% System Accuracy Over Temperature  
• Microprocessor Voltage Identification Input  
- 5-Bit VID Input  
- 1.100V to 1.850V in 25mV Steps  
- Programmable “Droop” Voltage  
• Fast Transient Recovery Time  
• Over Current Protection  
• High Ripple Frequency, (Channel Frequency) Times  
Number Channels . . . . . . . . . . . . . . . . . 100kHz to 3MHz  
Ordering Information  
Outstanding features of this controller IC include  
programmable VID codes from the microprocessor that  
range from 1.100V to 1.850V with a system accuracy of  
±1%. Pull up currents on these VID pins eliminates the need  
for external pull up resistors. In addition “droop”  
compensation, used to reduce the overshoot or undershoot  
of the CORE voltage, is easily programmed with a single  
resistor.  
o
PART NUMBER  
TEMP. ( C)  
PACKAGE  
PKG. NO.  
HIP6302CB  
0 to 70  
16 Ld SOIC  
M16.15  
HIP6302CB-T  
HIP6302EVAL1  
16 Ld SOIC Tape and Reel  
Evaluation Platform  
Pinout  
HIP6302 (SOIC)  
TOP VIEW  
Another feature of this controller IC is the PGOOD monitor  
circuit which is held low until the CORE voltage increases,  
during its Soft-Start sequence, to within 10% of the  
programmed voltage. Over-voltage, 15% above programmed  
CORE voltage, results in the converter shutting down and  
turning the lower MOSFETs ON to clamp and protect the  
microprocessor. Under voltage is also detected and results  
in PGOOD low if the CORE voltage falls 10% below the  
programmed level. Over-current protection reduces the  
regulator current to less than 25% of the programmed trip  
value. These features provide monitoring and protection for  
the microprocessor and power system.  
VID4  
1
2
3
4
5
6
7
8
16 V  
CC  
VID3  
VID2  
15 PGOOD  
14 ISEN1  
13 PWM1  
12 PWM2  
11 ISEN2  
10 VSEN  
VID1  
VID0  
COMP  
FB  
FS/DIS  
9
GND  
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.  
1-888-INTERSIL or 321-724-7143 | Copyright © Intersil Corporation 2000  
1

与HIP6302相关器件

型号 品牌 描述 获取价格 数据表
HIP6302_04 INTERSIL Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller

获取价格

HIP6302CB INTERSIL Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller

获取价格

HIP6302CB-T INTERSIL Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller

获取价格

HIP6302CB-T RENESAS SWITCHING CONTROLLER, 1500kHz SWITCHING FREQ-MAX, PDSO16, PLASTIC, MS-012-AC, SOIC-16

获取价格

HIP6302CBZ INTERSIL Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller

获取价格

HIP6302CBZA INTERSIL Microprocessor CORE Voltage Regulator Multi-Phase Buck PWM Controller

获取价格