Datasheet > HAS-251M

HAS-251M

更新时间： 2022-02-26 13:50:38

品牌	Logo	应用领域
华兴安 - HUAXINAN		/
页数	文件大小	规格书
8页	339K
描述
Small capacitance and excellent insulation resistance

阅读下载

获取价格

数据手册

如果您发现信息不准确，欢迎纠错

HAS-251M 数据手册

9 Mechanical Characteristics机构特性 :

试验项目

试验方法

结果

Test Item

Test Method

Result

拉力强度(依据 JIS C0051) 施加 2.5Kgf 之荷重于导线约 30 秒钟后,检测直流开始放电电压,

满足各个特性之规格值

Within standard

mentioned in Initial

Characteristics.

满足各个特性之规格值

Within standard

mentioned in Initial

Characteristics.

Pull Strength (JIS C0051)

绝缘阻抗,靜电容量及检查外观. (Apply 2.5 kgs load

approximately 30 seconds, then check for pull-out and breaking

of the lead wire.)

弯曲強度 (依据 JIS C0051) 距离导线熔接点根部 3mm 处,使用曲率半径 0.75~0.80mm 之治

Flexure Strength(JIS

C0051)

具,与轴方向垂直角度,荷 0.25Kgf 弯曲后回复原状,反复 2 次后,

检测直流开始放电电压,绝缘阻抗,靜电容量及检查外观.(Bend

the lead wire, with jig which radius is 0.75~0.8mm, at the point

of 3mm from the body, under 0.25 kgs load applied at the right

angle the direction of the amis and get the bent lead wire back

to its original poing after the procedure was repeated 2 times.)

10 Solder Characteristics 焊锡特性 :

试验项目

试验方法

结果

Result

Test Item

Test Method

焊锡附着性

将沾过助焊剂之导线，自距离导线熔接点根部 3mm 处起，浸于

導線須均勻附著 90%上.

(依据 JIS C0050 4.6 项) 265±5℃之焊锡液中 5 秒钟后，将导线之助焊剂洗净后，检查焊锡附 (Lead wire is evenly

Solderability (JIS

C0050,4.6)

着情形.(Apply flux and immerse in molten solder, up to the point

covered by solder over

of 3mm from the body,for 5 sec. (265℃±5℃). Wash the leadwire and 90%.)

check for soldering adhesion.)

焊锡耐热性

(依据 JISC0051)

Solder Heat

将沾过助焊剂之导线，自距离导线熔接点根部 2mm 处起，浸于

265±5℃之焊锡液中 10 秒钟后,检测直流开始放电电压,绝缘阻抗,靜电

容量及检查外观. (Lead wire is dipped up to the point of

2mm from the body, into 265℃±5℃ solder.for 10±1 sec.And

measure the properties.)

满足各個特性之规格值

Within standard

mentioned in Initial

Characteristics.

(JIS C0051)

11 Surge Characteristics 突波特性 :

试验项目

试验方法

结果

Test Item

Test Method

Result

突波寿命(HAS)

将(10X700)μsec-6KV 突波,变换极向各 5 次,(100X1000)μsec-1KV 之突波,变换极向各 5 直流开始放电电压 HAS

次,每隔 30 秒施加于试料 24 次后,检测直流开始放电电压,绝缘阻抗,靜电容量及检查外观 △Vs/Vs≦30% (DC sparkover

(Apply a standard impulse voltage (10X700)μsec)of 1KV for 5 times with intervals of 30 volatage HAS:

sec., and then change the polarity of the surge and apply a impulse again. And similarly, △Vs/Vs≦30%)

apply a impulse voltage((100X1000)μsec) of 1KV. Total apply 24 times. Then measure

Life(HAS)

DC spark-over voltage, IR & Capacitance.)

突波寿命(HAS)

每间隔 10 秒施加 10KV 之电压于 1500PF 之电容器通过试料,做 200 次(Apply 10 KV

绝缘阻抗和静电电容:须满足规

Life(HAS)

voltage charged in 1500pF condenser and apply the current to the specimen,200 times 定值外观:无影响使用之显著缺

at 10 seconds of intervals.)

陷 (Insulation Resistance &

Capacitance to meet the

specified value.Appearance:

No cracks or failures .)

HUAAN LIMITED

www.huaandz.com

1 2 3 456 7 8

下载PDF

与HAS-251M相关器件

型号	品牌	描述	获取价格	数据表
HAS300-P	LEM	Current Transducers HAS 50~600-P	获取价格
HAS300-S	LEM	Current Transducers HAS 50 to 600-S	获取价格
HAS-30-R	MSYSTEM	Space-saving Plug-in Signal Conditioners H-UNIT	获取价格
HAS-30-R/Q	MSYSTEM	Space-saving Plug-in Signal Conditioners H-UNIT	获取价格
HAS-31-R	MSYSTEM	Space-saving Plug-in Signal Conditioners H-UNIT	获取价格
HAS-31-R/Q	MSYSTEM	Space-saving Plug-in Signal Conditioners H-UNIT	获取价格

与HAS-251M相关文章

PCF8574资料解读：主要参数分析、引脚说明
2024-05-21

1
AD637数据手册解读：主要特性、引脚及其功能解读、电气参数
2024-05-21

3
ADUM1201资料手册解读：参数分析、引脚说明、应用分析
2024-05-21

3
一文带你了解压敏电阻器在直流电路中的过压保护作用
2024-05-21

3

产品中心

服务支持

精选活动

关于我们

帮助中心

HAS-251M

HAS-251M 数据手册

与HAS-251M相关器件

与HAS-251M相关文章

您还可以找

产品中心

服务支持

精选活动

关于我们

帮助中心

HAS-251M

HAS-251M 数据手册

与HAS-251M相关器件

与HAS-251M相关文章

您还可以找

您在本页遇到什么问题？