Global Mixed-mode Technology Inc.
G690/G691
Microprocessor Reset IC
Features
General Description
Precision Monitoring of +3V, +3.3V, and +5V
Power-Supply Voltages
The G690/G691 are microprocessor (µP) supervisory
circuits used to monitor the power supplies in µP and
digital systems. They provide excellent circuit reliability
and low cost by eliminating external components and
adjustments when used with +5V, +3.3V, +3.0V- pow-
ered circuits.
Fully Specified Over Temperature
Available in Three Output Configurations
Push-Pull RESET Output (G690L)
Push-Pull RESET Output (G690H)
Open-Drain RESET Output (G691L)
140ms min Power-On Reset Pulse Width
10µA Supply Current
Guaranteed Reset Valid to VCC = +1V
Power Supply Transient Immunity
No External Components
These circuits perform a single function: they assert a
reset signal whenever the VCC supply voltage declines
below a preset threshold, keeping it asserted for at
least 140ms after VCC has risen above the reset
threshold. Reset thresholds suitable for operation with
a variety of supply voltages are available.
3-Pin SOT-23 Packages
The G691L has an open-drain output stage, while the
G690 have push-pull outputs. The G691L’s open-drain
Applications
RESET output requires a pull-up resistor that can be
connected to a voltage higher than VCC. The G690L
Computers
Controllers
have an active-low RESET output, while the G690H
has an active-high RESET output. The reset com-
parator is designed to ignore fast transients on VCC,
and the outputs are guaranteed to be in the correct
logic state for VCC down to 1V.
Intelligent Instruments
Critical µP and µC Power Monitoring
Portable / Battery-Powered Equipment
Automotive
Low supply current makes the G690/G691 ideal for
use in portable equipment. The G690/G691 are avail-
able in 3-pin SOT-23 packages.
Pin Configuration
Typical Application Circuit
VCC
3
VCC
VCC
*
RPULL-UP
µP
G690/G691
RESET
INPUT
RESET
(RESET)
GND
GND
2
1
SOT-23
*G691 ONLY
TEL: 886-3-5788833
http://www.gmt.com.tw
Ver: 2.0
Aug 07, 2006
1