IEC Inlet Filters FN 9260
DATASHEET
General Purpose Power Entry Module with Fuses
Rated currents up to 10 A
Approvals & Compliances
Integrated single/dual fuse holder
Optional reduced leakage current versions (A/B
type)
Complies with IEC/EN 60601-1
Snap-in versions (S type)
Good attenuation performance
The FN 9260 power entry module combines an IEC
inlet, mains filter with excellent filter attenuation and
fuses in a small form factor. Choosing FN 9260
product line brings you rapid availability of a standard
filter associated with the necessary safety
Performance indicators
acceptances. Standard IEC connector filters are a
practical solution helping you to pass EMI system
approval in a short time. A wide selection on
amperage ratings, output connections, mounting
possibilities and filters for medical applications are
designed to offer you the desired solution.
Features and Benefits
Exceptional conducted attenuation performance,
based on chokes with high saturation resistance
and excellent thermal behavior
FN 9260 B versions comply with the requirements of
1MOP acc. to IEC/EN 60601-1 for creepage and
clearance, leakage current and high potential
testing
Technical specifications
250 VAC, 50/60 Hz
DC to 400 Hz
Maximum continuous operating voltage
Operating frequency
Versions up to 10 A are available with fuse holder for
one or two fuses
1 to 10 A @ 40°C max.
Rated currents
P –> PE 2000 VAC for 2 sec (standard types)
P –> PE 2500 VAC for 2 sec (B types)
P –> N 760 VAC for 2 sec
High potential test voltage
Custom-specific versions are available on request
IP 40 according to IEC 60529
-25°C to +85°C (25/85/21)
Protection category
Typical applications
Temperature range (operation and storage)
Design corresponding to
Portable electrical and electronic equipment
Medical equipment
UL 60939-3, CSA Std C22.2 No. 8, IEC/EN 60939-3, GB/
T15287, GB/T15288
Inlet plastic: UL 94 V-0
Flammability corresponding to
Small to medium-sized machines and household
equipment
Fuseholder plastic: UL 94 V-0
2,200,000 hours
MTBF @ 40°C/230 V (Mil-HB-217F)
Fuse holder
Single-phase power supplies, switch-mode power
supplies
Test and measurement equipment
1 or 2 fuses (Ø5 x 20 mm) (certified to IEC 60127-6)
250 VAC, 50/60 Hz
Operating voltage
Typical electrical schematic