High Speed Industrial CAN Transceiver
with Bus Protection for 24 V Systems
Data Sheet
ADM3051
FEATURES
FUNCTIONAL BLOCK DIAGRAM
V
CC
Physical layer CAN transceiver
5 V operation on VCC
THERMAL
Complies with ISO 11898 standard
High speed data rates up to 1 Mbps
Short-circuit protection on CANH and CANL against shorts to
power/ground in 24 V systems
Unpowered nodes do not disturb the bus
Connect 110 or more nodes on the bus
Slope control for reduced EMI
SHUTDOWN
TxD
RS
D
MODE
CANH
CANL
R
RxD
Thermal shutdown protection
Low current standby mode
Industrial operating temperature range (−40°C to +125°C)
Available in 8-lead SOIC package
VOLTAGE
REFERENCE
V
REF
ADM3051
APPLICATIONS
GND
CAN data buses
Figure 1.
Industrial field networks
DeviceNet applications
CanOpen, CanKingdom
GENERAL DESCRIPTION
The ADM3051 is a controller area network (CAN) physical
layer transceiver allowing a protocol layer CAN controller to
access the physical layer bus. The ADM3051 complies with
the ISO 11898 standard. It is capable of running at data rates up
to 1 Mbps.
Three operating modes are available: high speed, slope control,
and standby. Pin 8 (RS) is used to select the operating mode.
The low current standby mode can be selected by applying a
logic high to RS.
The device can be set to operate with slope control to limit EMI
by connecting RS with a resistor to ground to modify the rise
and fall of slopes. This mode facilitates the use of unshielded
cables. Alternatively, disabling slope control by connecting RS
to ground allows high speed operation. Shielded cables or other
measures to control EMI are necessary in this mode.
The device has current-limiting and thermal shutdown features
to protect against output short circuits and situations where the
bus may be shorted to ground or power terminals in 24 V bus
power systems. The part is fully specified over the industrial
temperature range of −40°C to +125°C and is available in an
8-lead SOIC package.
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registeredtrademarks arethe property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
Fax: 781.461.3113
www.analog.com
©2011 Analog Devices, Inc. All rights reserved.