RoHS
Pb
EPS13D2C1HC-32.000M
EPS13D2 C 1 H C -32.000M
Series
Nominal Frequency
32.000MHz
RoHS Compliant (Pb-free) 3.3V 4 Pad 5mm x 7mm
Ceramic SMD LVCMOS Programmable Spread
Spectrum Oscillator
Spread Spectrum
±0.75% Center Spread
Frequency Stability
±100ppm Maximum over Operating Temperature Range
of -20°C to +70°C
Output Control Function
Tri-State
Duty Cycle
50% ±10%
ELECTRICAL SPECIFICATIONS
Nominal Frequency
32.000MHz
Frequency Stability
±100ppm Maximum over Operating Temperature Range of -20°C to +70°C (Inclusive of all conditions:
Frequency Stability over the Operating Temperature Range, Supply Voltage Change, Output Load Change,
First Year Aging at 25°C, Shock, and Vibration.)
Aging at 25°C
±5ppm First Year Maximum
3.3Vdc ±0.3Vdc
Supply Voltage
Maximum Supply Voltage
Input Current
-0.5Vdc to +7.0Vdc
30mA Maximum (Unloaded; Vdd=3.3Vdc)
Vdd-0.4Vdc Minimum (IOH=-8mA)
0.4Vdc Maximum (IOL=+8mA)
2.7nSec Maximum (Measured at 20% to 80% of Waveform)
50% ±10% (Measured at 50% of Waveform)
15pF Maximum
Output Voltage Logic High (Voh)
Output Voltage Logic Low (Vol)
Rise/Fall Time
Duty Cycle
Load Drive Capability
Output Logic Type
Output Control Function
CMOS
Tri-State (High Impedance Internal Pull Down Resistor of 100kOhms Typical on Pad 3, Internal Pull Up
Resistor of 100kOhms Typical on Pad 1)
Tri-State Input Voltage (Vih and Vil)
Tri-State Output Disable Time
Tri-State Output Enable Time
Disable Current
70% of Vdd Minimum or No Connection to Enable Output, 30% of Vdd Maximum to Disable Output
350nSec Maximum
350nSec Maximum
20mA Maximum (Unloaded; Pad 1=Ground; Vdd=3.3Vdc)
±0.75% Center Spread
Spread Spectrum
Modulation Frequency
Period Jitter
30kHz Minimum, 31.5kHz Typical, 33kHz Maximum
400pSec Maximum (Cycle to Cycle; Spread Spectrum-On; Vdd=3.3Vdc)
10mSec Maximum
Start Up Time
Storage Temperature Range
-55°C to +125°C
ENVIRONMENTAL & MECHANICAL SPECIFICATIONS
Fine Leak Test
MIL-STD-883, Method 1014, Condition A
MIL-STD-883, Method 1014, Condition C
MIL-STD-202, Method 213, Condition C
MIL-STD-202, Method 210
Gross Leak Test
Mechanical Shock
Resistance to Soldering Heat
Resistance to Solvents
Solderability
MIL-STD-202, Method 215
MIL-STD-883, Method 2003
Temperature Cycling
Vibration
MIL-STD-883, Method 1010
MIL-STD-883, Method 2007, Condition A
www.ecliptek.com | Specification Subject to Change Without Notice | Rev B 2/17/2010 | Page 1 of 5