CYWM6934
PRELIMINARY
the ETSI 301 489-17 (immunity testing) is strongly recom-
mended. Cypress assumes no responsibility for compliance of
the end-product configuration.
documentation must indicate the use restrictions of the end-
product (i.e. countries disallowing the operating frequencies of
the CYWM6934).
Product Labeling Requirements
Note:
European Union product labeling requirements stipulate
specific text be placed on the device containing the
CYWM6934 module. The product label must include the
following text and must be affixed to the exterior of the OEM’s
product. (As shown in the ‘Correct Labeling’ section 4.1.3).
This same information may be included in the product user
manual, however this is not mandatory. Packaging and user
The end-product must be labeled "CE" and to the right of the
CE mark, the label should have '!' with a circle around it. The
exclamation mark designates a non-harmonized frequency
band.
5.0
Pin Definitions
Table 5-1. Pin Description Table for the CYWM6934
Pin QFN
Name
Direction
Description
GND
–
Ground
1
2
VCC
–
Supply voltage for the entire Radio Module (2.7V-3.6V). It is recommended that 3.3V be
used for most applications.
3
4
IRQ
nRESET
MOSI
nSS
Output Interrupt signal from Radio Module to the MCU
Input
Input
Input
Active low reset signal from MCU to Radio Module
Master out, slave in SPI signal from MCU to Radio Module
Active low slave select signal from MCU to Radio Module
5
6
7
SCK
Input
SPI clock from MCU to Radio Module
MISO
Output Master in, slave out SPI signal from Radio Module to MCU
8
9
GND
nPD
N/C
–
Input
–
Ground
10
11
12
Active low power-down signal from MCU to Radio Module
No connect—leave open
N/C
–
No connect—leave open
12-pin
2mm
header
GND
IRQ
1
3
5
7
9
2
4
VCC
nRESET
nSS
MOSI
SCK
GND
N/C
6
8
MISO
nPD
10
11 12
N/C
Figure 5-1. CYWM6934 Header Pin-out
Document 38-16012 Rev. *A
Page 5 of 9
[+] Feedback