Datasheet > CS1108

CS1108

更新时间： 2022-04-23 23:00:11

品牌	Logo	应用领域
安森美 - ONSEMI		驱动
页数	文件大小	规格书
4页	45K
描述
Single Lamp Driver IC

阅读下载

获取价格

数据手册

如果您发现信息不准确，欢迎纠错

CS1108 数据手册

CS1108

CIRCUIT DESCRIPTION

The CS1108 lamp driver IC provides up to 350 mA of

Typical lamps have a low resistance when off and the

current will exceed the current limit threshold during the

initial inrush period. During this inrush time, the IC will be

operating in the duty cycle mode. Due to characteristics of

lamps in this mode, they may appear dimly lit. This

condition will persist for a breif time until the lamp

resistance has increased enough to reduce it’s current below

the threshold. Once this occurs the lamp will appear at full

brightness. During the inrush period the Fault pin will be

forced low indicating that duty cycle mode is in operation.

Thermal protection has been designed into this IC. Should

duty cycle mode operate for an extended amount of time and

the power limitations of the IC are exceeded the IC die

temperature will rise. Once the die temperature reaches the

thermal temperature limit, the internal cicuitry will shutoff

the output and the lamp will turn off. Once the die temperature

lowers below the thermal threshold, the output will be

allowed to turn back on.

drive current in a low–side configuration. The Output driver

pin is controlled through the TTL compatible Control input

pin. A high condition on the Control pin turns the output pin

on.

The Fault pin reports short circuit, open circuit, and

overtemperature conditions on the IC. If a fault is present,

the open collector output Fault pin will be low. Typical

numbers for faults are: exceeding 500 mA of drive current

will report a short circuit. Less than 40 mA (typical) will

report an open circuit. A temperature fault will be reported

when the die temperature exceeds 180°C (typical). Faults

are only reported when the Control pin is high, due to the low

quiescent current when the Control pin is low and the output

device is turned off.

The CS1108 is designed to provide overcurrent protection

by duty cycle control. When the lamp current exceeds the

internally programmed current limit threshold (typically

500 mA), the output enters duty cycle mode to reduce power

dissipation of the IC to a safe level.

Output

GND

CS1108

10 nF

GND

Fault

20 k

GND

Control

BAT

microprocessor

Figure 2. Applications Diagram

http://onsemi.com

1 234

下载PDF

与CS1108相关器件

型号	品牌	描述	获取价格	数据表
CS-1108	ETC	Single Lamp Driver IC	获取价格
CS1108/D	ETC	Single Lamp Driver IC	获取价格
CS-1108D8	ETC	Single Peripheral Driver	获取价格
CS-1108DR8	ETC	Single Peripheral Driver	获取价格
CS1108EDF8	CHERRY	Single Lamp Driver IC	获取价格
CS1108EDF8	ONSEMI	Single Lamp Driver IC	获取价格