CAT24CXX1/XX2
Advanced
ABSOLUTE MAXIMUM RATINGS*
COMMENT
Temperature Under Bias....................–55°C to +125°C
Storage Temperature........................ –65°C to +150°C
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
These are stress ratings only, and functional operation
of the device at these or any other conditions outside of
those listed in the operational sections of this specifica-
tion is not implied. Exposure to any absolute maximum
rating for extended periods may affect device perfor-
mance and reliability.
Voltage on Any Pin with
(1)
Respect to Ground
..............–2.0V to +V
+ 2.0V
CC
VCC with Respect to Ground..................–2.0V to +7.0V
Package Power Dissipation
Capability (Ta = 25°C)1.0W.................................1.0W
Lead Soldering Temperature (10 secs)...............300°C
Output Short Circuit Current(2) ..........................100mA
RELIABILITY CHARACTERISTICS
Symbol
Parameter
Min.
Max. Units
Reference Test Method
(3)
NEND
Endurance
1,000,000
100
Cycles/Byte
Years
MIL-STD-883, Test Method 1033
MIL-STD-883, Test Method 1008
MIL-STD-883, Test Method 3015
JEDEC Standard 17
(3)
TDR
Data Retention
ESD Susceptibility
Latch-up
(3)
VZAP
2000
Volts
(3)(4)
ILTH
100
mA
D.C. OPERATING CHARACTERISTICS
V
CC
= +2.7V to +6.0V, unless otherwise specified.
Limits
Symbol
ICC
Parameter
Min.
Typ. Max.
Units
mA
Test Conditions
fSCL = 100 KHz
Vcc=3.3V
Power Supply Current
Standby Current
3
Isb
40
µA
50
2
µA
µA
µA
V
Vcc=5
ILI
Input Leakage Current
Output Leakage Current
Input Low Voltage
VIN=GND or VCC
VIN=GND or VCC
ILO
10
VIL
–1
VCC x 0.3
VIH
VOL
Input High Voltage
VCC x 0.7
VCC + 0.5
0.4
V
Output Low Voltage (SDA)
V
IOL = 3 mA ,VCC=3.0V
CAPACITANCE T = 25°C, f = 1.0 MHz, V
= 5V
A
CC
Symbol
Test
Max.
Units
Conditions
VI/O = 0V
VIN = 0V
(3)
CI/O
Input/Output Capacitance (SDA)
Input Capacitance (SCL)
8
6
pF
pF
(3)
CIN
Note:
(1) The minimum DC input voltage is –0.5V. During transitions, inputs may undershoot to –2.0V for periods of less than 20 ns. Maximum DC
voltage on output pins is V +0.5V, which may overshoot to V + 2.0V for periods of less than 20ns.
CC
CC
(2) Output shorted for no more than one second. No more than one output shorted at a time.
(3) This parameter is tested initially and after a design or process change that affects the parameter.
(4) Latch-up protection is provided for stresses up to 100 mA on address and data pins from –1V to V +1V.
CC
Doc. No. 25079-00 1/98 M-1
2