BM63374S-VA BM63374S-VC
Mechanical Characteristics And Ratings
Limit
Item
Unit
Following Standard
-
Conditions
Min
Typ
Max
0.78
Mounting Screw M3 (Note 1)
Recommended 0.69N・m (Note 2)
Mounting Torque
0.59
0.69
N・m
Load
Pin Pulling Strength
Pin Bending Strength
10
2
-
-
-
-
s
EIAJ-ED-4701/400
EIAJ-ED-4701/400
Control Pin:4.9N
Power Pin:9.8N
Load
Control Pin: 2.45N
Power Pin:4.9N
90deg. Bend
times
Weight
-
10
-
-
g
-
-
Measurement point
Heat Sink Flatness
0
+200
µm
is provided in Figure 6-1.
(Note 1) Plain washers of 8mm outside diameter (ISO 7089 to 7094) are recommended.
(Note 2) When installing a module to a heat sink, excessive uneven fastening force might apply stress to inside chips or ceramic of heat sink plate, which will
break or crack or degrade a module. An example of recommended fastening sequence is shown in Figure 5. The temporary fastening torque is set to
20 to 30% of the maximum torque rating. Evenly apply thermally-conductive grease with 100µm to 200µm thickness over the contact surface
between the module and the heat sink. Also, pay attention not to have any dirt left on the contact surface between the module and the heat sink.
It is recommended to install a module directly to a heat sink after applying grease. When installing a module to a heat sink, inserting a heat radiation
sheet between a module and a heat sink might apply stress depending on thickness and elastic modulus of the sheet to inside chips or ceramic of
heat sink plate, which will break or crack or degrade a module. When using a heat radiation sheet, it is needed to prevent IPM from bending into +
side of Figure 6-2.
2
Temporary fastening:1→2
Permanent fastening:1→2
1
Figure 5. Example of Recommended Fastening Sequence
TOP VIEW
(+)
(+)
(+)
Heat Radiation Sheet
Heatsink
Figure 6-2. Flatness after Installing to a Heat Sink
(When Using a Heat Radiation Sheet)
Figure 6-1. Measurement Point of
Heat Sink Flatness
www.rohm.com
TSQ50501-BM63374S-2
30.Jul.2020 Rev.001
© 2020 ROHM Co., Ltd. All rights reserved.
7/21
TSZ22111・15・001