Datasheet > B84143V0045R127

B84143V0045R127

更新时间： 2024-03-03 10:08:13

品牌	Logo	应用领域
东电化 - TDK		/
页数	文件大小	规格书
13页	746K
描述
Rated Current=45A Rated Voltage=520V AC

阅读下载

获取价格

数据手册

如果您发现信息不准确，欢迎纠错

B84143V0045R127 数据手册

Output filters

B84143V*R127

3-line sine-wave EMC output filters SineFormer

The table below summarizes the safety instructions that must be observed without fail. A detailed

description can be found in the relevant chapters of the databook.

Reference chapter

(data book),

Topic

Instructions

paragraph

Selecting a filter

When selecting a filter, it is mandatory to observe the Selection guide for

rated data of the equipment (such as its rated input

current, rated voltage, harmonic content etc.) as well

as the derating instructions in Chapters 9 and 10.

converter filters

Rated voltage

When power distribution systems deviating from the

symmetric TN-S system is to check the suitability of

the filters and the allowed voltages including the fault

cases.

Power distribution

systems,

Protection from

Active parts must be discharged within 5 s to a Safety regulations,

residual voltages

voltage of less than 60 V (or 50 μ C). If this limit 6.1

Discharge resistors cannot be observed due to the operating mode, the

hazardous point must be permanently marked in a

clearly visible way.

Filters which are not permanently connected (e.g.

when the test voltage is applied to the filter at the

incoming goods inspection) must be discharged after

the voltage has been switched off.

Safety regulations,

6.2

Installing and

removing of filters

When installing and removing our filters, a Safety regulations,

voltage-free state must be set up and secured with 6.4

observance of the five safety rules described in

EN 50110-1.

Installation

Use in IT systems The special features of the IT system ("first fault case" Power distribution

and other fault cases) shall be observed.

system (network

types), 7.6

Safety notes on

leakage currents

The filter leakage currents specified in the data book Leakage current,

are intended for user information only.The maximum 8.4

leakage current of the entire electrical equipment or Leakage current,

appliance has to be limited for safety reasons. Please 8.6

obtain the applicable limits for your application from

the relevant regulations, provisions and standards.

Voltage derating

If the permissible limits for the higher-frequency Voltage derating,

voltages at the filter are exeeded, the filter may be 9.8

damaged or destroyed.

Hazards caused by

overloading the

filters

Current derating at Non-observance of the current derating may lead to Current derating,

elevated ambient

temperatures

overheating and consequently represents a fire 10.1

hazard.

Please read Cautions and warnings and

Important notes at the end of this document.

Page 9 of 13

1...6 7 8910 11 12 13

下载PDF

与B84143V0045R127相关器件

型号	品牌	描述	获取价格	数据表
B84143V0050R227	EPCOS	3-line filters Sine-wave output filter	获取价格
B84143V0050R227	TDK	Rated Current=50A Rated Voltage=520V AC	获取价格
B84143V0050R229	TDK	Rated Current=50A Rated Voltage=300/520V AC	获取价格
B84143V0056R230	TDK	Rated Current=56A Rated Voltage=400/690V AC	获取价格
B84143V0064R231	TDK	Rated Current=64A Rated Voltage=230/400V AC	获取价格
B84143V0066R127	EPCOS	3-line sine-wave EMC output filters for converters and power electronics -SineFormer-	获取价格