Datasheet > AQ533

AQ533

更新时间： 2022-04-23 23:00:11

品牌	Logo	应用领域
ACUTECH		稳压器
页数	文件大小	规格书
10页	634K
描述
Ultra-Low Dropout 500mA Voltage Regulator

阅读下载

获取价格

如果您发现信息不准确，欢迎纠错

AQ533 数据手册

Acutechnology Semiconductor Inc.

AQ533

from the adjust terminal could introduce error to the output, but since it is very small (<0.5µA)

compared with the current I2 and very constant with line and load changes, the error can be

ignored. The constant current I2 then flows through resistor R1 and sets the output voltage to

the desired level.

The AQ533 regulates the voltage that appears between its output and ground pins or

between its adjust and ground pins. In some cases, line resistances can introduce errors to

the voltage across the load. To obtain the best load regulation a few precautions are needed.

For example, it is important to minimize the line resistances to the load. So, the load itself

should be tied directly to the output terminal on the positive side and directly to the ground

terminal on the negative side.

The best performance is obtained with the positive side of the resistor R1 tied near the load

and with the ground side of the resistor R2 tied near the ground of the regulator. This will

provide remote output sensing which will optimize regulation at the load.

4. Enable/Sequencing

The AQ533 provides an enable function. The EN pin has to be at least 950 mV higher than

the output voltage for the device to be fully turned on. When the voltage of the EN pin is low

the device is in shutdown mode and it will not draw any current from the VIN terminal.

ENABLE

OUT

FIG.2 ENABLE 0-5V, Output follows to 3.3V out

(1V/div vertical, 200us/div horizontal)

In addition the enable function includes a sequencing feature, because when the enable pin

ramps in voltage the output voltage follows (it will be around 900 mV less than the enable

voltage until it reaches the regulation voltage) as shown in Fig. 2 above.

In applications where multiple regulated supply rails are required, it is often required that the

relationship between the various supply voltages be controlled during start-up and shutdown.

To this end, the AQ533 allows for an analog control of the output voltage via the ENABLE pin.

This allows for sequential, ratio-metric and simultaneous sequencing schemes.

5. Reverse Current Protection

www.acutechnology.com

Rev. 1.7 September 13, 2006

1...4 5 678 9 10

下载PDF

型号	品牌	描述	获取价格	数据表
AQ533CY-M5-18-TR	ACUTECH	Ultra-Low Dropout 500mA Voltage Regulator	获取价格
AQ533CY-M5-18-TRL	ACUTECH	Ultra-Low Dropout 500mA Voltage Regulator	获取价格
AQ533CY-M5-25-TR	ACUTECH	Ultra-Low Dropout 500mA Voltage Regulator	获取价格
AQ533CY-M5-25-TRL	ACUTECH	Ultra-Low Dropout 500mA Voltage Regulator	获取价格
AQ533CY-M5-33-TR	ACUTECH	Ultra-Low Dropout 500mA Voltage Regulator	获取价格
AQ533CY-M5-33-TRL	ACUTECH	Ultra-Low Dropout 500mA Voltage Regulator	获取价格