Datasheet > AQ533

AQ533

更新时间： 2022-04-23 23:00:11

品牌	Logo	应用领域
ACUTECH		稳压器
页数	文件大小	规格书
10页	634K
描述
Ultra-Low Dropout 500mA Voltage Regulator

阅读下载

获取价格

如果您发现信息不准确，欢迎纠错

AQ533 数据手册

Acutechnology Semiconductor Inc.

AQ533

Application Notes

1. Typical Application

Notes:

1. Output voltage is 1.22V * (R1 +R2)/R2

2. Input and output capacitors should be located close to the device.

3. The AQ533 will remain stable with C1 and C3 as low as 0.1 µF and 1.0 µF respectively.

Overall transient performance is improved with increased capacitance and the addition of C2.

4. The output is fully enabled when Enable is 950 mV above the expected VOUT. EN may

be driven by either a digital or analog signal to control either turn-on time or to give full

control of risetime.

5. Enable, tied to any separate source >0.95V + VOUT, will insure Ultra-low drop out voltage

(350mV@ 500mA) from VIN to VOUT. Or, Enable, tied to Vin will support a low drop out

voltage (0.95V).

2. Stability

An Enable capacitor is recommended. A 100nF capacitor is a suitable input bypass for

almost all applications. A larger capacitor is also suitable depending on the cleanliness of the

Enable source.

A Vin Capacitor is also recommended. A 1µF capacitor is a bypassing for almost all applications.

A larger capacitor is also suitable depending on the cleanliness of the VIN source.

The Output capacitor is critical in maintaining regular stability. The AQ533 is stable with an

output capacitor greater than 1µF. Any increase of the output capacitor will merely improve

the loop stability and the load transient response.

Tantalum Capacitors exhibit the best stability over a wide range of loads and are recommended.

3. Output Voltage

The AQ533 meets all specifications down to 1.22V output. It does not suffer from

performance degradation issues such as experienced with CMOS LDO’s. Drop out voltage

will be less than 350 mV at 500 mA load with the ENABLE pin held greater than 0.95V + Vout,

The AQ533 develops a 1.22V reference voltage between the adjust pin terminal and ground.

This voltage is applied across the resistor R2 to generate a constant current (I2). The current

www.acutechnology.com

Rev. 1.7 September 13, 2006

1...3 4 567 8 9 10

下载PDF

型号	品牌	描述	获取价格	数据表
AQ533CY-M5-18-TR	ACUTECH	Ultra-Low Dropout 500mA Voltage Regulator	获取价格
AQ533CY-M5-18-TRL	ACUTECH	Ultra-Low Dropout 500mA Voltage Regulator	获取价格
AQ533CY-M5-25-TR	ACUTECH	Ultra-Low Dropout 500mA Voltage Regulator	获取价格
AQ533CY-M5-25-TRL	ACUTECH	Ultra-Low Dropout 500mA Voltage Regulator	获取价格
AQ533CY-M5-33-TR	ACUTECH	Ultra-Low Dropout 500mA Voltage Regulator	获取价格
AQ533CY-M5-33-TRL	ACUTECH	Ultra-Low Dropout 500mA Voltage Regulator	获取价格