rxLOOP INPUT
THEORY OF OPERATION
rxLOOP is the loopback control signal. When enabled, the
rxLINEP and rxLINEN inputs are disconnected from the
AFE. The rxHYBP and rxHYBN inputs remain connected.
Loopback is enabled by applying a positive signal (Logic 1)
to rxLOOP.
The transmit channel consists of a switched-capacitor pulse
forming network followed by a differential line driver. The
pulse forming network receives symbol data from the XMIT
and XMITB outputs of the Bt8952 and generates a 2B1Q
output waveform. The output meets the pulse mask and
power spectral density requirements defined in European
Telecommunications Standards Institute document RTR/
TM-03036 for E1 mode and in sections 6.2.1 and 6.2.2.1 of
Bellcore technical advisory TA-NWT-001210 for T1 mode.
The differential line driver uses a composite output stage
combining class B operation (for high efficiency driving
large signals) with class AB operation (to minimize cross-
over distortion).
ECHO CANCELLATION IN THE AFE
The rxHYB input is designed to be subtracted from the
rxLINE input for first order echo cancellation. To accom-
plish this, note that the rxLINE input is connected to the
same polarity signal at the transformer (positive to positive
and negative to negative) while the rxHYB input is con-
nected to opposite polarity through the compromise hybrid
(negative to positive and positive to negative) as shown in
Figure 2.
The receive channel is designed around a fourth-order delta
sigma A/D converter. It includes a difference amplifier
designed to be used with an external compromise hybrid for
first order analog crosstalk reduction. A programmable gain
amplifier with gains of 0dB to +9dB is also included. The
delta sigma modulator operating at a 24X oversampling ratio
produces 14 bits of resolution at output rates up to 584kHz.
The basic functionality of the AFE1103 is illustrated in
Figure 1 shown below.
RECEIVE DATA CODING
The data from the receive channel A/D converter is coded in
offset binary.
ANALOG INPUT
OUTPUT CODE (rxD13 - rxD0)
Positive Full Scale
Negative Full Scale
11111111111111
00000000000000
The receive channel operates by summing the two differen-
tial inputs, one from the line (rxLINE) and the other from the
compromise hybrid (rxHYB). The connection of these two
inputs so that the hybrid signal is subtracted from the line
signal is described in the paragraph titled “Echo Cancella-
tion in the AFE”. The equivalent gain for each input in the
difference amp is 1. The resulting signal then passes to a
programmable gain amplifier which can be set for gains of
0dB through 9dB. The ADC converts the signal to a
14-bit digital word, rxD13-rxD0.
RECEIVE CHANNEL PROGRAMMABLE
GAIN AMPLIFIER
The gain of the amplifier at the input of the Receive Channel
is set by two gain control pins, rxGAIN1 and rxGAIN0. The
resulting gain between 0dB and +9dB is shown below.
rxGAIN1
rxGAIN0
GAIN
0dB
0
0
1
1
0
1
0
1
3.25dB
6dB
9dB
txDATP
txLINEP
txLINEN
Pulse Former
txDATN
Differential
Line Driver
rxHYBP
rxHYBN
14
ADC
rxD13 - rxD0
rxLINEP
rxLINEN
Programmable
Gain Amp
Difference
Amplifier
FIGURE 1. Functional Block Diagram of AFE1103.
®
AFE1103
6