ADSP-2183
Table II.
PMOVLAY Memory A13
Memory Architecture
The ADSP-2183 provides a variety of memory and peripheral
interface options. The key functional groups are Program
Memory, Data Memory, Byte Memory and I/O.
A12:0
0
1
Internal
Not Applicable Not Applicable
Program Memory is a 24-bit-wide space for storing both
instruction opcodes and data. The ADSP-2183 has 16K words
of Program Memory RAM on chip and the capability of access-
ing up to two 8K external memory overlay spaces using the
external data bus. Both an instruction opcode and a data value
can be read from on-chip program memory in a single cycle.
External
Overlay 1
0
1
13 LSBs of Address
Between 0x2000
and 0x3FFF
2
External
13 LSBs of Address
Between 0x2000
and 0x3FFF
Overlay 2
Data Memory is a 16-bit-wide space used for the storage of
data variables and for memory-mapped control registers. The
ADSP-2183 has 16K words on Data Memory RAM on chip,
consisting of 16,352 user-accessible locations and 32 memory-
mapped registers. Support also exists for up to two 8K external
memory overlay spaces through the external data bus.
This organization provides for two external 8K overlay segments
using only the normal 14 address bits. This allows for simple
program overlays using one of the two external segments in
place of the on-chip memory. Care must be taken in using this
overlay space because the processor core (i.e., the sequencer)
does not take the PMOVLAY register value into account. For
example, if a loop operation were occurring on one of the exter-
nal overlays, and the program changes to another external over-
lay or internal memory, an incorrect loop operation could occur.
In addition, care must be taken in interrupt service routines as
the overlay registers are not automatically saved and restored on
the processor mode stack.
Byte Memory provides access to an 8-bit-wide memory space
through the Byte DMA (BDMA) port. The Byte Memory inter-
face provides access to 4 MBytes of memory by utilizing eight
data lines as additional address lines. This gives the BDMA Port
an effective 22-bit address range. On power-up, the DSP can
automatically load bootstrap code from byte memory.
I/O Space allows access to 2048 locations of 16-bit-wide data.
It is intended to be used to communicate with parallel periph-
eral devices such as data converters and external registers or
latches.
For ADSP-2100 Family compatibility, MMAP = 1 is allowed.
In this mode, booting is disabled and overlay memory is dis-
abled (PMOVLAY must be 0). Figure 5 shows the memory map
in this configuration.
Program Memory
The ADSP-2183 contains a 16K × 24 on-chip program RAM.
The on-chip program memory is designed to allow up to two
accesses each cycle so that all operations can complete in a
single cycle. In addition, the ADSP-2183 allows the use of 8K
external memory overlays.
PROGRAM MEMORY
ADDRESS
0x3FFF
INTERNAL 8K
(PMOVLAY = 0,
MMAP = 1)
0x2000
0x1FFF
The program memory space organization is controlled by the
MMAP pin and the PMOVLAY register. Normally, the ADSP-
2183 is configured with MMAP = 0 and program memory orga-
nized as shown in Figure 4.
8K EXTERNAL
0x0000
PROGRAM MEMORY
ADDRESS
0x3FFF
Figure 5. Program Memory (MMAP = 1)
Data Memory
The ADSP-2183 has 16,352 16-bit words of internal data
memory. In addition, the ADSP-2183 allows the use of 8K
external memory overlays. Figure 6 shows the organization of
the data memory.
8K INTERNAL
(PMOVLAY = 0,
MMAP = 0)
OR
EXTERNAL 8K
(PMOVLAY = 1 or 2,
MMAP = 0)
0x2000
0x1FFF
DATA MEMORY
ADDRESS
8K INTERNAL
0x3FFF
32 MEMORY–
MAPPED REGISTERS
0x0000
0x3FEO
0x3FDF
Figure 4. Program Memory (MMAP = 0)
INTERNAL
8160 WORDS
There are 16K words of memory accessible internally when the
PMOVLAY register is set to 0. When PMOVLAY is set to
something other than 0, external accesses occur at addresses
0x2000 through 0x3FFF. The external address is generated as
shown in Table II.
0x2000
0x1FFF
8K INTERNAL
(DMOVLAY = 0)
OR
EXTERNAL 8K
(DMOVLAY = 1, 2)
0x0000
Figure 6. Data Memory
REV. C
–7–
5秒后页面跳转
MAX6675资料手册参数详解、引脚配置说明
LM258引脚图及功能介绍、主要参数分析
CD4052资料手册参数详解、引脚配置说明
一文带你了解TPS5430资料手册分析：参数介绍、引脚配置说明
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
技术参数
数据手册
如果您发现信息不准确，
