Data Sheet
ADP1614
PIN CONFIGURATION AND FUNCTION DESCRIPTIONS
COMP 1
FB 2
10 SS
9
8
7
6
CLRES
ADP1614
TOP VIEW
(Not to Scale)
EN 3
VIN
SW
SW
GND 4
GND 5
NOTES
1. THE EXPOSED PAD IS NOT ELECTRICALLY
CONNECTED; CONNECT THIS PAD TO A GROUND
PLANE FOR BETTER HEAT DISTRIBUTION.
Figure 2. Pin Configuration
Table 4. Pin Function Descriptions
Pin No.
Mnemonic
COMP
FB
Description
1
2
Compensation Input. Connect a series resistor-capacitor network from COMP to GND to compensate the regulator.
Output Voltage Feedback Input. Connect a resistive voltage divider from the output voltage to FB to set the
regulator output voltage.
3
4, 5
6, 7
EN
GND
SW
Enable Input. Drive EN low to shut down the regulator; drive EN high to turn on the regulator.
Ground.
Switching Output. Connect the power inductor from the input voltage to SW and connect the external rectifier
from SW to the output voltage to complete the step-up converter.
8
VIN
Main Power Supply Input. VIN powers the ADP1614 internal circuitry. Connect VIN to the input source voltage.
Bypass VIN to GND with a 10 µF or greater capacitor as close to the ADP1614 as possible.
9
10
CLRES
SS
Connect a resistor to GND to set the peak inductor current.
Soft Start. A capacitor connected from SS to GND brings up the output slowly at power-up and reduces inrush
current.
11
EP
Exposed Die Attach Pad. The exposed pad is not electrically connected; connect this pad to a ground plane for
better heat distribution.
Rev. 0 | Page 5 of 16