PRELIMINARY TECHNICAL DATA
ActiveandApparentEnergyMeteringIC
a
PreliminaryTechnicalData
withdi/dtsensorinterface
ADE7753*
precise phase matching between the current and voltage
channels. T he integrator can be switched on and off based on
the current sensor selected.
T he AD E7753 contains an Active Energy register. It is
capable of holding more than 200 seconds of accumulated
power at full load. Data is read from the ADE7753 via the
serial interface. T he ADE7753 also provides a pulse output
(CF) with output frequency is proportional to the active
power.
In addition to rms calculation and active and apparent power
information, the AD E7753 also accumulates the signed
reactive energy. T he ADE7753 also provides various system
calibration features, i.e., channel offset correction, phase
calibration and power calibration. T he part also incorporates
a detection circuit for short duration low or high voltage
variations.
T he ADE7753 has a positive only accumulation mode which
gives the option to accumulate energy only when positive
power is detected. An internal no-load threshold ensures that
the part does not exhibit any creep when there is no load.
A zero crossing output (ZX) produces an output which is
synchronized to the zero crossing point of the line voltage.
T his information is used in the ADE7753 to measure the
line's period. T he signal is also used internally to the chip in
the line cycle Active and Apparent energy accumulation
mode. T his enables a faster and more precise energy accumu-
lation and is useful during calibration. T his signal is also
useful for synchronization of relay switching with a voltage
zero crossing.
FEATURES
High Accuracy, supports IEC 61036 and IEC61268
On-Chip Digital Integrator enables direct interface w ith
current sensors w ith di/ dt output
The ADE7753 supplies Active, Reactive and Apparent
Energy, Sam pled Waveform , Current and Voltage RMS
Less than 0.1% error over a dynam ic range of 1000 to 1
Positive only energy accum ulation m ode available
An On-Chip user Program m able threshold for line
voltage surge and SAG, and PSU supervisory
Digital Pow er, Phase & Input Offset Calibration
An On-Chip tem perature sensor (±3°C typical)
A SPI com patible Serial Interface
A pulse output w ith program m able frequency
An Interrupt Request pin (IRQ) and Status register
Proprietary ADCs and DSP provide high accuracy data over
large variations in environm ental conditions and tim e
Reference 2.4V±8% (20 ppm / °C typical)
w ith external overdrive capability
Single 5V Supply, Low pow er (25m W typical)
GENERAL DESCRIP TION
T he AD E7753 is an accurate active and apparent energy
measurements IC with a serial interface and a pulse output.
T he ADE7753 incorporates two second order sigma delta
AD Cs, a digital integrator (on CH 1), reference circuitry,
temperature sensor, and all the signal processing required to
perform RMS calculation on the voltage and current, active,
reactive, and apparent energy measurement.
T he interrupt request output is an open drain, active low logic
output. T he Interrupt Status Register indicates the nature of
the interrupt, and the Interrupt Enable Register controls
which event produces an output on the IRQ pin.
An on-chip digital integrator provides direct interface to di/
dt current sensors such as Rogowski coils. T he digital
integrator eliminates the need for external analog integrator,
and this solution provides excellent long-term stability and
T he ADE7753 is available in 20-lead SSOP package.
FUNCTIO NAL BLO CK D IAGRAM
DVDD
DGND
AVDD
RESET
ADE7753
WGAIN[11:0]
PGA
INTEGRATOR
MULTIPLIER
LPF2
V1P
V1N
+
-
ADC
Ύdt
Σ
HPF
CFNUM[11:0]
TEMP
SENSOR
APOS[15:0]
PHCAL[5:0]
DFC
CF
Φ
CFDEN[11:0]
IRMSOS[11:0]
VAGAIN[11:0]
2
X
Σ
ZX
PGA
VRMSOS[11:0]
V2P
V2N
SAG
+
-
ADC
2
X
Σ
VADIV[7:0]
WDIV[7:0]
LPF1
4kΩ
2.4V
REFERENCE
ADE7753 REGISTERS &
SERIAL INTERFACE
REF
DIN DOUT SCLK CS IRQ
AGND
IN/OUT
CLKIN CLKOUT
*U.S. Patents 5,745,323; 5,760,617; 5,862,069; 5,872,469; others Pending.
REV. PrF 10/02
Inform ation furnished by Analog Devices is believed to be accurate and
reliable. However, no responsibility is assum ed by Analog Devices for its
use, nor for any infringem ents of patents or other rights of third parties
which m ay result from its use. No license is granted by im plication or
otherwise under any patent or patent rights of Analog Devices.
One Technology Way, P.O. Box 9106, Norwood. MA 02062-9106, U.S.A.
Tel: 781/329-4700
Fax: 781/326-8703
w w w . a n a l o g . c o m
© Analog Devices, Inc., 2002