5秒后页面跳转
AD9814JR PDF预览

AD9814JR

更新时间: 2024-01-20 18:26:23
品牌 Logo 应用领域
罗彻斯特 - ROCHESTER 光电二极管
页数 文件大小 规格书
16页 843K
描述
SPECIALTY ANALOG CIRCUIT, PDSO28, 0.300 INCH, SOIC-28

AD9814JR 技术参数

是否无铅: 含铅是否Rohs认证: 不符合
生命周期:Active零件包装代码:SOIC
包装说明:SOP,针数:28
Reach Compliance Code:unknown风险等级:5.63
模拟集成电路 - 其他类型:ANALOG CIRCUITJESD-30 代码:R-PDSO-G28
JESD-609代码:e0长度:17.9 mm
湿度敏感等级:1功能数量:1
端子数量:28最高工作温度:70 °C
最低工作温度:封装主体材料:PLASTIC/EPOXY
封装代码:SOP封装形状:RECTANGULAR
封装形式:SMALL OUTLINE峰值回流温度(摄氏度):240
认证状态:COMMERCIAL座面最大高度:2.65 mm
最大供电电压 (Vsup):5.25 V最小供电电压 (Vsup):4.75 V
标称供电电压 (Vsup):5 V表面贴装:YES
技术:CMOS温度等级:COMMERCIAL
端子面层:TIN LEAD端子形式:GULL WING
端子节距:1.27 mm端子位置:DUAL
处于峰值回流温度下的最长时间:30宽度:7.5 mm
Base Number Matches:1

AD9814JR 数据手册

 浏览型号AD9814JR的Datasheet PDF文件第3页浏览型号AD9814JR的Datasheet PDF文件第4页浏览型号AD9814JR的Datasheet PDF文件第5页浏览型号AD9814JR的Datasheet PDF文件第7页浏览型号AD9814JR的Datasheet PDF文件第8页浏览型号AD9814JR的Datasheet PDF文件第9页 
AD9814  
INPUT REFERRED NOISE  
DEFINITIONS OF SPECIFICATIONS  
The rms output noise is measured using histogram techniques.  
The ADC output codes’ standard deviation is calculated in  
LSB, and converted to an equivalent voltage, using the relation-  
ship 1 LSB = 4 V/16384 = 244 mV. The noise is then referred  
to the input of the AD9814 by dividing by the PGA gain.  
INTEGRAL NONLINEARITY (INL)  
Integral nonlinearity error refers to the deviation of each indi-  
vidual code from a line drawn from “zero scale” through “posi-  
tive full scale.” The point used as “zero scale” occurs 1/2 LSB  
before the first code transition. “Positive full scale” is defined as  
a level 1 1/2 LSB beyond the last code transition. The deviation  
is measured from the middle of each particular code to the true  
straight line.  
CHANNEL-TO-CHANNEL CROSSTALK  
In an ideal three channel system, the signal in one channel will  
not influence the signal level of another channel. The channel-  
to-channel crosstalk specification is a measure of the change that  
occurs in one channel as the other two channels are varied. In  
the AD9814, one channel is grounded and the other two chan-  
nels are exercised with full-scale input signals. The change in the  
output codes from the first channel is measured and compared  
with the result when all three channels are grounded. The differ-  
ence is the channel-to-channel crosstalk, stated in LSB.  
DIFFERENTIAL NONLINEARITY (DNL)  
An ideal ADC exhibits code transitions that are exactly 1 LSB  
apart. DNL is the deviation from this ideal value. Thus every  
code must have a finite width. No missing codes guaranteed to  
14-bit resolution indicates that all 16384 codes, respectively,  
must be present over all operating ranges.  
OFFSET ERROR  
APERTURE DELAY  
The first ADC code transition should occur at a level 1/2 LSB  
above the nominal zero scale voltage. The offset error is the  
deviation of the actual first code transition level from the ideal  
level.  
The aperture delay is the time delay that occurs from when a  
sampling edge is applied to the AD9814 until the actual sample  
of the input signal is held. Both CDSCLK1 and CDSCLK2  
sample the input signal during the transition from high to low,  
so the aperture delay is measured from each clock’s falling edge  
to the instant the actual internal sample is taken.  
GAIN ERROR  
The last code transition should occur for an analog value  
1 1/2 LSB below the nominal full-scale voltage. Gain error is  
the deviation of the actual difference between first and last code  
transitions and the ideal difference between the first and last  
code transitions.  
POWER SUPPLY REJECTION  
Power Supply Rejection specifies the maximum full-scale change  
that occurs from the initial value when the supplies are varied  
over the specified limits.  
REV. 0  
–5–  

与AD9814JR相关器件

型号 品牌 描述 获取价格 数据表
AD9814KR ADI Complete 14-Bit CCD/CIS Signal Processor

获取价格

AD9814KR ROCHESTER SPECIALTY ANALOG CIRCUIT, PDSO28, 0.300 INCH, SOIC-28

获取价格

AD9814KRRL ADI IC SPECIALTY ANALOG CIRCUIT, PDSO28, 0.300 INCH, SOIC-28, Analog IC:Other

获取价格

AD9814KRRL ROCHESTER SPECIALTY ANALOG CIRCUIT, PDSO28, 0.300 INCH, SOIC-28

获取价格

AD9814S ADI 14-Bit CCD/CIS Signal Processor

获取价格

AD9816 ADI Complete 12-Bit 6 MSPS CCD/CIS Signal Processor

获取价格