Datasheet > 电源电路 > 开关式稳压器或控制器> AAT1156IVN-T1

AAT1156IVN-T1

更新时间： 2024-02-03 09:41:52

品牌	Logo	应用领域
ANALOGICTECH		转换器稳压器开关式稳压器或控制器电源电路开关式控制器
页数	文件大小	规格书
14页	425K
描述
1MHz 700mA Step-Down DC-DC Converter

阅读下载

获取价格

技术参数
数据手册

如果您发现信息不准确，欢迎纠错

AAT1156IVN-T1 技术参数

生命周期：	Active	包装说明：	,
Reach Compliance Code：	unknown	风险等级：	5.69
Is Samacsys：	N	Base Number Matches：	1

AAT1156IVN-T1 数据手册

AAT1156

1MHz 700mA Step-Down DC-DC Converter

Functional Block Diagram

VCC

V_P= 2.7V to 5.5V

1.0V REF

CMP

OP. AMP

LOGIC

1MΩ

OSC

Temp.

Sensing

SGND

PGND

still providing sufficient DC loop gain for good load

regulation. The voltage loop crossover frequency

and phase margin are set by the output capacitor.

Operation

Control Loop

The AAT1156 is a peak current mode step-down

converter. The inner, wide bandwidth loop controls

the inductor peak current. The inductor current is

sensed through the P-channel MOSFET (high

side) and is also used for short-circuit and overload

protection. A fixed slope compensation signal is

added to the sensed current to maintain stability for

duty cycles greater than 50%. The loop appears

as a voltage-programmed current source in paral-

lel with the output capacitor.

Soft Start/Enable

Soft start increases the inductor current limit point in

discrete steps once the input voltage or enable

input is applied. It limits the current surge seen at

the input and eliminates output voltage overshoot.

When pulled low, the enable input forces the

AAT1156 into a non-switching shutdown state. The

total input current during shutdown is less than 1µA.

The voltage error amplifier output programs the

current loop for the necessary inductor current to

force a constant output voltage for all load and line

conditions. The external voltage feedback resistive

divider divides the output voltage to the error ampli-

fier reference voltage of 0.6V. The voltage error

amplifier DC gain is limited. This eliminates the

need for external compensation components, while

Power and Signal Source

Separate small signal ground and power supply

pins isolate the internal control circuitry from the

noise associated with the output MOSFET switch-

ing. The low pass filter R1 and C2 (shown in the

schematic in Figure 1) filters the input noise asso-

ciated with the power switching.

1156.2005.11.1.2

1...4 5 678 9 10...14

下载PDF

与AAT1156IVN-T1相关器件

型号	品牌	描述	获取价格	数据表
AAT1157	ANALOGICTECH	1MHz 1.2A Buck DC/DC Converter	获取价格
AAT1157IVN-3.3-T1	ANALOGICTECH	Switching Regulator/Controller,	获取价格
AAT1157IVN-T1	ANALOGICTECH	1MHz 1.2A Buck DC/DC Converter	获取价格
AAT1160	ANALOGICTECH	12V, 3A Step-Down DC/DC Converter	获取价格
AAT1160	AAT	Step Up Current Mode PWM Converter with 4+1 Operational Amplifiers	获取价格
AAT1160IRN-0.6-T1	ANALOGICTECH	12V, 3A Step-Down DC/DC Converter	获取价格