A80606 and
A80606-1
High Power LED Driver with Pre-Emptive Boost
for Ultra-High Dimming Ratio and Low Output Ripple
DESCRIPTION (continued)
Switchingfrequencycanbeexternallysynchronizedorprogrammed
between 200 kHz and 2.3 MHz. This allows operation either above
or below the AM band. A programmable dithering feature further
reduces EMI. A clock-out is provided for other converters to sync
to the A80606.
The A80606 provides protection against output short, overvoltage,
open- or shorted-LED pin, and overtemperature. A cycle-by-cycle
current limit protects the external boost switch against high current
overloads. An external P-MOSFET can optionally be used to
disconnect input supply in case of output to ground short fault. The
A80606-1 is similar toA80606 except it adopts ‘One-Out-All-Out’
fault handling (See Fault Table section for details).
SELECTION GUIDE [1]
Part Number
A80606KEVJSR
A80606KEVJSR-1
Fault Handling
One-Out-Continue
One-Out-All-Out
LED Driver
Package
Packing
48-pin 7 mm × 7 mm wettable flank QFN
with exposed thermal pad and sidewall plating
4000 pieces
per 13-inch reel
6 × 180 mA
[1] Contact Allegro for additional packing options.
ABSOLUTE MAXIMUM RATINGS [2]
Characteristic
Symbol
Notes
Rating
Unit
LEDx Pin
OVP pin
VIN
VLEDx
VOVP
VIN
x = 1..6
–0.3 to 40
–0.3 to 40
V
V
V
–0.3 to 40
Higher of –0.3
and (VIN – 7.4) to
VIN +0.4
VSENSE
VGATE
,
VSENSE, GATE
V
VDRV, GDRV
CS
VDRV, VGDRV
VCS
–1.0 to 7.5
–0.3 to 7
V
V
EN, PWM, FAULT, ADIM, COMP,
DITH, PEB, FSET, ISET, VDD
External input signals must not be higher than VIN + 0.4 V
–0.3 to 5.5
V
Maximum Junction Temperature
Storage Temperature
TJ(max)
Tstg
150
°C
°C
–55 to 150
[2] Stresses beyond those listed in this table may cause permanent damage to the device. The absolute maximum ratings are stress ratings only,
and functional operation of the device at these or any other conditions beyond those indicated in the Electrical Characteristics table is not implied.
Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
THERMAL CHARACTERISTICS: May require derating at maximum conditions; see application information
Characteristic
Symbol
Test Conditions [4]
Value
Unit
Package Thermal Resistance
RθJA
EV package measured on 4-layer PCB based on JEDEC standard
24
°C/W
[4] Additional thermal information available on the Allegro website.
2
Allegro MicroSystems
955 Perimeter Road
Manchester, NH 03103-3353 U.S.A.
www.allegromicro.com