PCMCIA Flash Memory Card
FLV Series
White Electronic Designs
ABSOLUTE MAXIMUM RATINGS (1)
Operating Temperature TA (ambient)
Commercial
0°C to +60 °C
-40°C to +85°C
Industrial
Storage Temperature
Commercial
-30°C to +80 °C
-40°C to +85°C
-0.5V to VCC+0.5V
-0.5V to +7.0V
Industrial
Voltage on any pin relative to VSS
VCC supply Voltage relative to VSS
Note: Stress greater than those listed under “Absolute Maximum Ratings” may cause permanent
damage to the device. This is a stress rating only and functional operation at these or any other
conditions greater than those indicated in the operational sections of this specification is not
implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.
DC CHARACTERISTICS (1)
VCC = 3.3V/5V
Symbol
Parameter
Density
Notes
3.3V VCC
5V VCC
Units
Test Conditions
(Mbytes)
Typ(3)
Max
Typ(3)
Max
ICCR
ICCW
ICCE
VCC Read Current
All
All
10
12
20
35
mA
mA
VCC = VCC max
tcycle = 150ns, CMOS levels
VCC Program Current
28F008SC
28F016SC
60
75
VCC Erase Current
All
40
50
mA
µA
ICCS
(CMOS)
VCC Standby Current
2MB
20MB
4MB
40MB
2
50
400
50
200
60
420
60
230
VCC = VCC max
Control Signals = VCC
Reset = VSS, CMOS levels
28F008SC
2
200
230
28F016SC
400
420
CMOS Test Conditions: VCC = 5V ± 5%, VIL = VSS ± 0.2V, VIH = VCC ± 0.2V
Notes:
1. All currents are RMS values unless otherwise specified. ICCR, ICCW and ICCE are based on Byte wide operations. For 16 bit operation values are double.
2. Control Signals: CE1#, CE2#, OE#, WE#, REG#.
3. Typical: VCC = 5V, T = +25°C.
Symbol Parameter
Notes
Min
Max
Units
Test Conditions
ILI
Input Leakage Current
1
±20
µA
VCC = VCCMAX
VIN =VCC or VSS
ILO
Output Leakage Current
1
±20
µA
VCC = VCCMAX
VOUT =VCC or VSS
VIL
VIH
Input Low Voltage
Input High Voltage
Output Low Voltage
Output High Voltage
1
1
1
1
1
0
0.8
VCC+0.5
0.4
V
V
V
V
V
0.7xVCC
VOL
VOH
VLKO
IOL = 3.2mA
IOH = -2.0mA
VCC-0.4
VCC
VCC Erase/Program
2.0
Lock Voltage
Notes:
1. Values are the same for byte and word wide modes for all card densities.
2. Exceptions: Leakage currents on CE1#, CE2#, OE#, REG# and WE# will be < 500 µA when VIN = GND due to internal pull-up resistors. Leakage currents on RST will be <150µA
when VIN=VCC due to internal pull-down resistor.
White Electronic Designs Corp. reserves the right to change products or specifications without notice.
June, 2003
Rev. 5
5
White Electronic Designs Corporation • (602) 437-1520 • www.wedc.com