Portable, Modular Signal Conditioning Modules
NI SCC-A10 Voltage Attenuator
Model
Channel
Description
Part Number
SCC-A10
2
Attenuator input
777459-0±
The National Instruments SCC-A10 is a dual-channel module that
accepts input voltage sources up to ±0 VDC. Each channel of the
NI SCC-A10 includes a 10:1 attenuation circuit and differential
instrumentation amplifier with low-impedance outputs for maximum
scanning rates by the multifunction DAQ device. The attenuation circuit
includes high-impedance bias resistors, so you can connect floating or
ground-referenced inputs to the SCC-A10 without adding external bias
resistors. The SCC-A10 also provides overvoltage protection (up to
250 Vrms) for your DAQ system.
When you install an SCC-A10 module in the SC-2345, the carrier
routes the attenuated input signals to two input channels of the DAQ
device, channels x and x+8, where x is 0 through 7.
Specifications
SCC-A10
Input Characteristics
Number of channels............................ 2 differential
Input range.......................................... ±±0 VDC
Output range ....................................... ±± VDC
Gain error ............................................ ±0.14ꢀ of reading, maximum
Offset error.......................................... ±±.5 mV maximum (referred
to input)
Input impedance
Normal powered on or off.............. 1 MΩ
Full power bandwidth......................... 10 kHz
Power Requirements
Analog................................................. 90 mW
BUY ONLINE at ni.com or CALL 800 813 3693 (U.S.)
11