EiceDRIVER™
6ED003L06-F2, 6ED003L02-F2
EiceDRIVER™
3 phase 600 V gate drive IC
1
Overview
Main features
Thin-film-SOI-technology
PG-DSO28
Maximum blocking voltage +600V
Separate control circuits for all six drivers
CMOS and LSTTL compatible input (negative logic)
Signal interlocking of every phase to prevent cross-conduction
Detection of over current and under voltage supply
externally programmable delay for fault clear after over current
detection
PG-TSSOP28
Product highlights
Insensitivity of the bridge output to negative transient voltages up to -50V given by SOI-technology
'shut down' of all switches during error conditions
Typical applications
Home appliances
Fans, pumps
General purpose drives
Product family
Table 1
Members of 6ED family – 2nd generation
high side control input typ. UVLO-
HIN1,2,3 and LIN1,2,3 Thresholds
Sales Name
Bootstrap Package
diode
6ED003L06-F2 / 6ED003L02-F2 negative logic
11.7 V / 9.8 V No
DSO28 / TSSOP28
Description
The devices are full bridge drivers to control power devices like MOS-transistors or IGBTs in 3-phase systems
with a maximum blocking voltage of +600 V. Based on the used SOI-technology there is an excellent
ruggedness on transient voltages. No parasitic thyristor structures are present in the device. Hence, no parasitic
latch-up may occur at all temperatures and voltage conditions.
The six independent drivers are controlled at the low-side using CMOS resp. LSTTL compatible signals, down
to 3.3 V logic. The device includes an under-voltage detection unit with hysteresis characteristic and an over-
current detection. The over-current level is adjusted by choosing the resistor value and the threshold level at pin
ITRIP. Both error conditions (under-voltage and over-current) lead to a definite shut down of all six switches. An
error signal is provided at the FAULT open drain output pin. The blocking time after over-current can be
adjusted with an RC-network at pin RCIN. The input RCIN owns an internal current source of 2.8 µA. Therefore,
the resistor RRCIN is optional. The typical output current can be given with 165 mA for pull-up and 375 mA for pull
down. Because of system safety reasons a 310 ns interlocking time has been realised. The function of input EN
can optionally be extended with an over-temperature detection, using an external NTC-resistor (see Fig.1).
datasheet
5
<Revision 2.8>, 05.08.2016