Instruction Sheet
PRO-CRIMPER* III Hand Crimping
Tool Assembly 58590-1 with
Die Assembly 58590-2
408-4353
06 NOV 09 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can resultfrom the prolonged use ofmanually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Stationary Jaw
Locator Assembly
(Supplied with
Back of Tool
(Wire Side)
Die Assembly)
Front of Tool
(Locator Side)
Pivot Pin
PRO-CRIMPER III Hand
Crimping Tool Frame
354940-1 (408-9930)
Die Assembly
Moving Jaw
Ratchet Adjustment Wheel
Stationary Handle
The PRO-CRIMPER III Hand Crimping Tool is a “Commercial” grade tool and
is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 series specification, but may not comply with other feature
parameters of the specification. Tyco Electronics offers a variety of tools to
satisfy your performance requirements. For additional information, contact the
Tooling Assistance Center at 1-800-722-1111.
Moving Handle
WIRE
TE Locator
Assembly{
Contact
Family}
TE Die Assembly
SIZE
INSUL DIA
(mm [in.])
STRIP LENGTH
(mm [in.])
(mm2)
1.5
2.21
Micro
Power
Quadlok
[.087]
4.00 -- 4.80
[.157 -- .189]
58590--2
58515--4
2.5
3.00
[.118]
{ Supplied with die assembly. Also available separately.
} Contact the TOOLING ASSISTANCE CENTER or PRODUCT ASSISTANCE (below) for specific contact part numbers.
Figure 1
Read these instructions thoroughly before crimping
any contacts.
1. INTRODUCTION
PRO--CRIMPER III Hand Crimping Tool Assembly
58590--1 consists of Die Assembly 58590--2 and
PRO--CRIMPER III Hand Crimping Tool Frame
354940--1. The die assembly consists of crimping
dies and a locator assembly.
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
NOTE
i
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
E2009 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
1 of 6
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
TE logo and Tyco Electronics are trademarks.
LOC B
*Trademark. Other products, logos, and company names used are the property of their respective owners.