440-001
EMI/RFI Crimp Ring Adapter
Direct Coupling - Standard Profile
440 F S 001 M 16 32-6
CONNECTOR
DESIGNATORS
Product Series
Length: S only
(1/2 inch increments:
e.g. 6 = 3 inches)
A-B*-C-D-E-F
G-H-J-K-L-S
Connector Designator
Angle and Profile
H = 45°
Cable Entry (Table V)
Shell Size (Table I)
Finish (Table II)
J = 90°
S = Straight
* Conn. Desig. B See Note 5
DIRECT COUPLING
Basic Part No.
J
E
Length *
* Length ± .060
(1.52)
(Table III) (Table IV)
A Thread
(Table I)
Min. Order
Length 1.5 Inch
(See Note 4)
K
**
F (Table IV)
O-Ring
B
(Table I)
B
L**
M**
(Table I)
Crimp Ring
Length ± .060 (1.52)
Min. Order Length 2.0 Inch
(See Note 4)
G
J
(Table III) (Table IV)
P**
R**
B
(Table I)
** (Table V)
STYLE 2
(STRAIGHT
See Note 1)
N**
H (Table IV)
See inside back cover fold-out or pages 13 and 14 for Tables I and II.
1. When maximum cable entry (page 22- Introduction) is exceeded, Style 2 will be supplied. (Function S only).
2. For proper installation of crimp ring, use Thomas & Betts (or equivalent) installation dies listed (Table V) for each
dash no.
3. Metric dimensions (mm) are indicated in parentheses.
4. Consult factory for shorter lengths on straight backshells.
5. When using Connector Designator B refer to pages 18 and 19 for part number development.
© 2005 Glenair, Inc.
CAGE Code 06324
Printed in U.S.A.
GLENAIR, INC. • 1211 AIR WAY • GLENDALE, CA 91201-2497 • 818-247-6000 • FAX 818-500-9912
www.glenair.com
E-Mail: sales@glenair.com
Series 440 - Page 8