ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
Table 3. Static Electrical Characteristics
Characteristics noted under conditions 3.0 V ≤ VIN ≤ 6.0 V, -40°C ≤ TA ≤ 85°C, GND = 0 V unless otherwise noted. Typical
values noted reflect the approximate parameter means at TA = 25°C under nominal conditions unless otherwise noted.
Characteristic
IC INPUT SUPPLY VOLTAGE (VIN)
Symbol
Min
Typ
Max
Unit
Input Supply Voltage Operating Range
VIN
IIN
3.0
-
-
-
6.0
25
V
Input DC Supply Current (11)
mA
Normal Mode: SD = 1 & STBY = 1, Unloaded Outputs
Input DC Supply Current (11)
IINQ
-
-
-
-
15
mA
µA
Standby Mode, SD = 1 & STBY = 0
Input DC Supply Current (11)
IINOFF
100
Shutdown Mode, SD = 0 & STBY = X
INTERNAL SUPPLY VOLTAGE OUTPUT (VDDI)
Internal Supply Voltage Range
VDDI
2.35
2.5
2.65
V
BUCK CONVERTER (PVIN, SW, GND, BOOT, INV, COMP)
High-side MOSFET Drain Voltage Range
Output Voltage Adjustment Range (12)
PVIN
VOUT
-
2.5
0.7
-
-
-
6.0
1.35
1.0
V
V
Output Voltage Accuracy (12), (13), (14)
-1.0
%
Line Regulation (12)
REGLN
REGLD
-1.0
-1.0
-
-
1.0
1.0
%
%
Normal Operation, VIN = 3.0 V to 6.0 V, IOUT = ±3.0 A
Load Regulation (12)
Normal Operation, IOUT = -3.0 A to 3.0 A
Error Amplifier Common Mode Voltage Range (12), (15)
V
0.0
-1.5
1.5
-3.0
-
-
1.35
-8.0
8.0
3.0
-
V
%
%
A
REF
Output Undervoltage Threshold
VUVR
VOVR
IOUT
ILIM
-
-
Output Overvoltage Threshold
Continuous Output Current
-
Over Current Limit, Sinking and Sourcing
4.0
A
Short Circuit Current Limit
(Sourcing and Sinking)
ISHORT
-
6.5
-
A
(12)
High-Side N-CH Power MOSFET (M3) RDS(ON)
RDS(ON)HS
10
10
-
-
45
45
mΩ
mΩ
IOUT = 1.0 A, VBOOT - VSW = 3.3 V
(12)
Low-Side N-CH Power MOSFET (M4) RDS(ON)
RDS(ON)LS
IOUT = 1.0 A, VIN = 3.3 V
Notes
11. See section “MODES OF OPERATION”, page 14 has a detailed description of the different operating modes of the 34712
12. Design information only, this parameter is not production tested.
13. ±1% is assured at room temperature.
14. Overall output accuracy is directly affected by the accuracy of the external feedback network, 1% feedback resistors are recommended.
15. The 1% output voltage regulation is only guaranteed for a common mode voltage range greater than or equal to 0.7V at room
temperature.
34712
Analog Integrated Circuit Device Data
Freescale Semiconductor
7