2D16WA_1.5RP Series
2W - Dual/Single Output - Wide Input - Isolated & Regulated
DC-DC Converter
DC-DC Converter
2 Watt
Miniature DIP package
2:1 wide input voltage range
Operating temperature:
-40°C to +85°C
No external component
required
Industry standard pinout
Internal SMD construction
Short circuit protection (SCP;
automatic recovery)
RoHS Compliance
The 2D16WAA_1.5RP series is specially designed for applications where
a wide range input voltage power supplies are isolated from the input
power supply in a distributed power supply system on a circuit board.
1500VDC isolation
These products apply to:
No heat sink required
1) Where the voltage of the input power supply is wide range
(voltage range ≤2:1)
2) Where isolation is necessary between input and output
(isolation voltage ≤1500VDC)
3) Where the regulation of the output voltage and the output ripple
noise are demanded.
Common specifications
Short circuit protection:
Filter:
Output specifications
Continuous, automatic recovery
Capacitor
Item
Test condition
Min
Typ
Max
2
Units
%
Voltage tolerance
Line regulation
Load regulation
Temperature drift
Temperature rise at full load:
Cooling:
15°C TYP
Regulated
Regulated
0.5
0.8
%
Free air convection
-40°C~+85°C
%
Operation temperature range:
Storage temperature range:
Lead temperature range:
Storage humidity range:
Case material:
Refer to recommended
circuit
0.03
%/°C
-55°C ~+125°C
Transient response
setting time
50% load step change
350
100
µs
300°C MAX, 1.5mm from case for 10 sec
< 95%
Ripple & Noise
20MHz Bandwidth
100
mVp-p
KHz
Plastic [UL94-V0]
>1,500,000 hours
5.2g
Switching frequency full load, nominal
input
MTBF:
Weight:
Dimensions:
24.1x14.35x8.25mm
Isolation specifications
Item
Test condition
Min
Typ
Max
Units
VDC
Isolation voltage
Tested for 1 minute
and 1mA max
1500
Example:
2D16WA_1205S1.5RP
Isolation resistance
Test at 500VDC
1000
MΩ
2= 2Watt; D16= DIP16; W= Wide Input 2:1; A= Pinning;
12 VDC nominal= 9-18Vin; 5Vout; S= Single Output; 1.5= 1500VDC
Isolation; R= Regulated Output; P= Short Circuit Protection
Note:
1. The load shouldn‘t be less than 10%, otherwise ripple will increase dramatically.
2. Operation under 10% load will not damage the converter; However, they may
not meet all specification listed.
3. All specifications measured at Ta=25°C, humidity <75%, nominal input voltage
and rated output load unless otherwise specified.
4. In this datasheet, all the test methods of indications are based on corporate
standards.
5. Only typical models listed, other models may be different, please contact our
technical person for more details.
Page 1 of 3
2D16WA_1.5RP – Rev. 2019-1.0
Specifications subject to change without notice.
GAPTEC-Electronic GmbH & Co. KG
sales@gaptec-electronic.com – www.gaptec-electronic.com