408-8959
8. TROUBLESHOOTING
Part
Inspection and Problem
Possible Solution
Inspect for cracks, gouges, nicks, or galling on the “C”-Head
or where the “C”-Head contacts dies
Return tool for repair (see Section 7)
Check to see if the upper die retaining pin does not hold the
stationary die in place
Return tool for repair (see Section 7)
“C”-Head
Check to see if the upper die release button sticks (it should
normally move in and out easily when moderate pressure is Return tool for repair (see Section 7)
applied)
If there are cracks, return the tool for repair (see
Section 7)
Inspect for evidence of cracks, gouges, nicks, or galling
Inspect for oil leaks between the cylinder and coupling
For traces of gouges, nicks, or galling: remove
any sharp edges using a fine emery cloth
Cylinder
For oil leaks and a sticky coupling, tighten or
replace the coupling
Check to see if the coupling sticks to the cylinder (it should
normally turn on and off freely when moderate pressure is
applied with a wrench)
Quick-Disconnect The coupling mates hard or will not mate or release, or it
Replace coupling
Coupling
leaks oil, or it sticks at the hose connection
If there are cracks or leaks, return the tool for
repair (see Section 7)
Inspect the ram in the Power “ON” (ram advanced) position
for evidence of galling, cracks, or oil leaks between the ram
and the cylinder
If there is galling, remove any sharp edges
using a fine emery cloth
Check to see if the lower die retaining pin does not hold the
moving die in place
Return tool for repair (see Section 7)
Ram
Check to see if the lower die release button sticks (it should
normally move in and out easily when moderate pressure is Return tool for repair (see Section 7)
applied)
Inspect the ram in the Power “OFF” (ram retracted) position
Return tool for repair (see Section 7)
to ensure that the ram returns freely to its original position
Figure 5
9. REVISION SUMMARY
Latest TE logo and formatting resulting in numbering changes of some paragraphs
Added Warning (paragraph 1)
Moved info on magnetic particle inspection from previous paragraph 5.1. to new paragraph 6.1.as a
NOTE
Added Section 8 TROUBLESHOOTING and Figure 5
6 of 6
Rev C