408-7779
Housing Bottomed
on PC Board
Grip Here
Protective Cover
PC Board
Clinched Contact Lead (Inward Only)
Figure 5
Cover Latch
For pc board soldering and cleaning procedures,
and recommended solvents, refer to Application
Specification 114 -1056.
NOTE
Figure 3
4. SWITCH PROGRAMMING
3.2. PC Board Installation
After the switch has been inserted into the DIP socket
or soldered onto the pc board, proceed as follows:
1. Make a layout on the pc board according to the
dimensions shown in Figure 4.
1. Remove seal from the switches, see Figure 6.
2. Make certain all contact leads have started entry
into holes. Grip sides of switch and push switch
into pc board until it is bottomed.
Remove Tape
Seal from
End
Low-Profile Switch
3. Hold switch at a slight angle and start one row
on contact leads into pc board holes. Do NOT
over--insert. Switch should be rotated until second
row of contact leads are aligned with opposite row
of contact holes.
Rotate to Align Second
Row - Then Push Down
on Ends of Switch
Use Light Pressure
to Insert Switch
Masking Material
Seal
Remove Seal from Top
Left to Bottom Right
(Diagonal Across the
Switch)
7.62 [.300] Ref
NOTE: These same procedures
apply to socket installation.
2.54 [.100] Ref
Figure 4
Standard-Profile or
Side-Actuated Switch
To hold switch in place during wave soldering, the
four outside contact leads may be clinched
inward at 45. Refer to Figure 5.
NOTE
Figure 6
Rev B
3 of 4