408-10021
CERTI-CRIMP II Tool Holder Assembly 1213860-1
1. Remove the quick--release pins shown in
Figure 4.
2. Insert the exposed portion of the crimping head
into the tool holder assembly cavity.
Switch
(Handle)
3. Insert the two outer quick--release pins through
the holes in the tool holder assembly, and through
the holes in the two outer tabs of the crimping
head.
Guide
Ram
The outer quick -release pins will “snap” into
position when they are properly inserted.
NOTE
i
4. Insert the center quick--release pin into the tool
holder assembly and through the holes in the ram
and the moveable die of the crimp head.
The center quick -release pin will “snap” into
position when it is properly inserted.
NOTE
i
The finished assembly should appear as shown in
Figure 5.
Figure 3
B. Removal
The center pin will be used to secure the movable die
of the crimp head to the ram of the tool holder
assembly.
To remove the crimping head, it will be necessary to
remove the three quick--release pins, and then
remove the crimp head from the tool holder assembly.
(Typical)
Quick-
Crimping
Release
Head
Pins
Quick-
Tool
Release
Holder
Pin
Assembly
SDE
Electric
Terminator
Quick-
Release
Pins
Figure 5
Guide Pin Removed
4. CRIMP HEIGHT ADJUSTMENT
Figure 4
Crimp height adjustment is required only if the crimp
height listed in the Tyco Electronics die specification
is not achieved.
A. Installation
These pins must be removed prior to installing the
crimping head.
Adjust the crimp height with a flat--bladed screwdriver.
Rev C
Tyco Electronics Corporation
3 of 5