5秒后页面跳转
1198 PDF预览

1198

更新时间: 2022-04-23 23:00:11
品牌 Logo 应用领域
德州仪器 - TI 射频
页数 文件大小 规格书
50页 595K
描述
Single Chip Low Cost Low Power RF-Transmitter

1198 数据手册

 浏览型号1198的Datasheet PDF文件第3页浏览型号1198的Datasheet PDF文件第4页浏览型号1198的Datasheet PDF文件第5页浏览型号1198的Datasheet PDF文件第7页浏览型号1198的Datasheet PDF文件第8页浏览型号1198的Datasheet PDF文件第9页 
CC1150  
6
RF Transmit Section  
Tc = 25°C, VDD = 3.0V, +10dBm if nothing else stated. Measured on Chipconís CC1150EM reference design.  
Parameter  
Min  
Typ  
Max  
Unit  
Condition/Note  
Differential load  
impedance  
TBD  
Follow CC1150EM reference design  
Output power,  
highest setting  
10  
dBm  
dBm  
Output power is programmable, and full range is available  
across all frequency bands.  
Delivered to a 50single-ended load via Chipcon reference  
RF matching network.  
Output power,  
lowest setting  
ñ30  
Output power is programmable, and full range is available  
across all frequency bands.  
Delivered to a 50single-ended load via Chipcon reference  
RF matching network.  
Spurious emissions  
and harmonics,  
433/868MHz  
ñ36  
ñ54  
ñ47  
dBm  
dBm  
dBm  
25MHz ñ 1GHz  
47-74, 87.5-118, 174-230, 470-862MHz  
1800MHz-1900MHz (restricted band in Europe), when the  
operating frequency is below 900MHz (2nd harmonic can not  
fall within this band when used in Europe)  
ñ30  
dBm  
Otherwise above 1GHz  
Spurious  
emissions,  
315/915MHz  
-49.2  
dBm  
<200µV/m at 3m below 960MHz.  
EIRP  
-41.2  
-20  
dBm  
EIRP  
<500µV/m at 3m above 960MHz.  
Harmonics  
315MHz  
dBc  
2nd, 3rd and 4th harmonic when the output power is maximum  
6mV/m at 3m. (-19.6dBm EIRP)  
-41.2  
-20  
dBm  
dBc  
5
th harmonic  
Harmonics  
915MHz  
2nd harmonic  
3rd, 4th and 5th harmonic  
-41.2  
dBm  
Table 5: RF Transmit Parameters  
7
Crystal Oscillator  
Tc = 25°C @ VDD = 3.0 V if nothing else is stated.  
Parameter  
Min  
Typ  
26  
Max  
Unit  
MHz  
ppm  
Condition/Note  
Crystal frequency  
Tolerance  
26  
27  
±40  
This is the total tolerance including a) initial tolerance, b) aging  
and c) temperature dependence.  
The acceptable crystal tolerance depends on RF frequency and  
channel spacing / bandwidth.  
ESR  
100  
Start-up time  
300  
µs  
Measured on Chipconís CC1150EM reference design. This  
parameter is to a large degree crystal dependent.  
Table 6: Crystal Oscillator Parameters  
Preliminary Data Sheet (rev. 1.0.)  
SWRS037  
Page 6 of 49  

与1198相关器件

型号 品牌 描述 获取价格 数据表
1198004-48M000 CTS

获取价格

1198091-5 TE D-SCE Fluid resistant heat-shrinkable wire identification sleeves

获取价格

1-1986160-2 TE PLUG HOUSING TERMINAL BLOCK, CRIMP STYLE, 5.08mm PITCH

获取价格

1-1986160-3 TE PLUG HOUSING TERMINAL BLOCK, CRIMP STYLE, 5.08mm PITCH

获取价格

1-1986160-4 TE PLUG HOUSING TERMINAL BLOCK, CRIMP STYLE, 5.08mm PITCH

获取价格

1-1986160-5 TE PLUG HOUSING TERMINAL BLOCK, CRIMP STYLE, 5.08mm PITCH

获取价格