Transient Voltage Suppression Diodes
10000W > 10KP Series
Trustworthy electronic circuit protection expert
10KP Series
●Weight: 2.30g
Features
●10000W peak pulse power capability at 10/1000μs
waveform, repetition rate (duty cycle): 0.05%
●Fast response time
●Typical IR less than 2μA above 30V.
●High Temperature soldering guaranteed: 265℃/10
seconds/.375″,(9.5mm) lead length, 5lbs (2.3kg) tension
●Plastic package has underwriters laboratory flammability
94V-0
P600
●Meets MSL level 1, per J-STD-020.
●Glass passivated junction
●Low incremental surge resistance
●Excellent clamping capability
Mechanical Data
●Case: Moulded plastic over glass passivated junction
● Terminal: Plated Axial leads, solderable per MIL-STD-750,
Method 2026
● Polarity: Color band denotes cathode except bi-directional
models
●Mounting Position: Any
Maximum Ratings (TA=25℃ unless otherwise noted)
Parameter
Symbol
PPPM
IPPM
Value
Minimum 10000
See Table
8.0
Unit
Peak pulse power dissipation at 10/1000μs waveform(Note1, Fig.1)
Peak pulse current of at 10/1000μs waveform (Note 1, Fig.3)
Steady state power dissipation at TL=75℃ (Fig.5)
Peak forward surge current, 8.3ms single half sine-wave
superimposed on rated load, (JEDEC Method) (Note2, Fig.6)
Operating junction and Storage Temperature Range.
Typical thermal resistance junction to lead
Watts
Amps
Watts
PM(AV)
IFSM
400
Amps
TJ,TSTG
RθJL
-55 to +175
℃
8
℃/W
℃/W
Typical thermal resistance junction to ambient
RθJA
40
Note:
1. Non-repetitive current pulse, per Fig.3 and derated above TA=25℃ per Fig.2.
2. 8.3ms single half sine-wave, or equivalent square wave, duty cycle=4 pulses per minutes maximum.
Electrical Characteristics (TA = 25 °C unless otherwise noted)
1
www.yint.com.cn
Rev:19.3