Datasheet > 09-06-2077

09-06-2077

更新时间： 2022-03-29 07:46:08

品牌	Logo	应用领域
莫仕 - MOLEX		/
页数	文件大小	规格书
6页	171K
描述
IDT CHANGE HEAD Specification Sheet

阅读下载

获取价格

如果您发现信息不准确，欢迎纠错

09-06-2077 数据手册

Change head for IDT Connectors Series

CAUTION: This change head should be used in accordance with the operation procedure. Any misuse may cause injury to

operator.

Quality

Check termination quality against the Molex wire termination specification for relevant product being terminated e.g.: PS-7674.

A quality procedure should be in place to monitor output from this Change Head.

The operating pistol handle is ratcheted to ensure correct wire insertion depth. This hand tool is set at the factory at a stroke of

11.7mm (.46”) and should not need adjusting. See Instruction Manual 63600-0478 for information.

Maintenance

It is recommended that each operator of the tool be made aware of, and responsible for, the following maintenance steps:

1. Keep Change Head clean at all times. Remove dust, moisture, and other contaminants with a clean brush, or soft, lint free

cloth.

2. Look into the track at the index and termination punch positions, if dirty or contains any plastic particles, then clean using a brush

or similar.

3. Do not use any abrasive materials that could damage the tool.

4. Make certain all pins; pivot points and bearing surfaces are protected with a thin coat of high quality machine oil. Do not oil

excessively.

5. When tool is not in use store the tool in a clean, dry area.

Warranty

This tool is made of the best quality materials. All vital components are long life tested. All tools are warranted to be free of

manufacturing defects for a period of 30 days. Should such a defect occur, we would exchange the tool free of charge. This will not

be applicable to altered, misused, or damaged tools. This tool is designed for hand use only. Any clamping, fixturing, or use of handle

extensions voids this warranty.

Molex does not repair this tool or offer any repair parts for this change head tool.

This tool is intended for low volume, prototyping, or repair requirements only. It is not intended as a production tool.

CAUTION: Molex termination specifications are valid only when used with Molex connectors and tooling.

Americas Headquarters Far East North Headquarters Far East South Headquarters European Headquarters Corporate Headquarters

Visit our Web site at http://www.molex.com

Doc No. 011215196

Revision: A

Release Date: 05-15-06

Revision Date: 05-15-06

UNCONTROLLED COPY

Page 6 of 6

1...3 4 56

下载PDF

型号	品牌	描述	获取价格	数据表
09-06-2078	MOLEX	IDT CHANGE HEAD Specification Sheet	获取价格
09-06-2079	MOLEX	IDT CHANGE HEAD Specification Sheet	获取价格
09-06-2080	MOLEX	3.96mm (.156") KK® IDT Trifurcon™ Contact, 8	获取价格
09-06-2087	MOLEX	IDT CHANGE HEAD Specification Sheet	获取价格
09-06-2088	MOLEX	IDT CHANGE HEAD Specification Sheet	获取价格
09-06-2089	MOLEX	IDT CHANGE HEAD Specification Sheet	获取价格