PRODUCT SPECIFICATION
Card mating/Unmating sequence:
a.) Insert the card at the angle
specified by the manufacturer
b.) Rotate the card into position.
c.) Reverse the installation sequence
to unmated
Operation Speed:25.4 ± 3 mm/minute.
Mating / Unmating
9ꢀ
Force: 2.3Kgf Maxꢀ
Forceꢀ
Measure the force required to
mate/Unmate connector.ꢀ
EIAꢁ364ꢁ13ꢀ
The sample should be mounted in the
tester and fully mated and unmated 50
cycles specified at the rate of 25.4 ± 3
mm/min.ꢀ
20 milliohms MAX.
(change from initial)
10ꢀ
Durabilityꢀ
Vibrationꢀ
EIAꢁ364ꢁ09ꢀ
The electrical load condition shall be 100
mA maximum for all contacts. Subject to
a simple harmonic motion having
amplitude of 0.76mm (1.52mm maximum
total excursion) in frequency between the
limits of 10 and 55 Hz. The entire
frequency range, from 10 to 55 Hz and
return to 10 Hz, shall be traversed in
approximately 1 minute. This motion shall
be applied for 2 hours in each of three
mutually perpendicular directions.
EIA-364-28ꢀ
20 milliohms MAX.
(change from initial)
&
11ꢀ
Discontinuity< 1 microsecond
Subject mated connectors to
50 G’s (peak value) half-sine shock pulses
of 11 milliseconds duration. Three shocks
in each direction shall be applied along
the three mutually perpendicular axes of
the test specimen (18 shocks). The
electrical load condition shall be 100mA
maximum for all contacts.
20 milliohms MAX.
(change from initial)
&
12ꢀ Shock (Mechanical)ꢀ
Discontinuity< 1 microsecond
EIA-364-27ꢀ
Apply axial pull out force at the speed
rate of 25 +/-3 mm/minute on the
terminal assembly in the housingꢀ
Terminal / Housing
13ꢀ
2.5 N Min.ꢀ
2.5 N Min.ꢀ
Retention Forceꢀ
Apply axial pull out force at the speed
rate of 25 +/-3 mm/minute on the
terminal assembly in the housingꢀ
Nail / Housing
14ꢀ
Retention Force
REVISION: ECR/ECN INFORMATION: TITLE:
SHEET No.
EC No:
DATE:
S2011-0490
2010 /11/30
0.8mm PITCH MINI PCI
5 of 8
B1
EXPRESS CONNECTOR
DOCUMENT NUMBER:
CREATED / REVISED BY:
CHECKED BY:
APPROVED BY:
JESSIECHUA 2010/11/30
KSSHANTHA 2010/11/30
NAGESHKN 2010/12/03
PS-48338-002
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A4](V.1).DOC