3 FPC/FFC の方向性 Direction of FPC/FFC
図のように導体露出面を下にし、補強板が上側になるように装着して下さい。
FPC/FFC shall be inserted as shown below with conductor side down and supporting tape side up.
補強板側
SUPPORTING TAPE SIDE
導体露出側
CONDUCTOR SIDE
4 アクチュエータ操作 Actuator operation
コネクタの破損防止の為、アクチュエータ操作は基板に半田付け後行うようにして下さい。
After soldering, a actuator shall be operated to prevent damage to a connector.
5 実装について Mounting
本製品は低背、省面積化を実現する為、インシュレータが非常に薄肉になっております。
従いまして、FPC 基板へのマウント等実装条件につきましては弊社と打合わせの上、確認して頂きますようお願い
致します。
また、FPC 実装の場合 FPC のたわみにより半田クラックなどが発生する可能性があります。
この為、実装部にはできるだけ厚い(少なくとも 0.3 mm 以上)補強板を貼り付けることを推奨します。
尚、本製品の実装エリア(投影エリア)へのシルク印刷は、コネクタ本体がシルク印刷上に乗り上げ、実装不良等の
原因となることがある為、避けて頂きますようご配慮願います。
リフロー加熱によりインシュレータ外表部にふくれが発生する場合がありますが、FPC/FFC の挿入及びコンタクトの
可動を妨げるものではなく、実使用上問題はありません。
Thin molding insulators realize the low-profile and small space character of this product.
Mounting conditions on FPC boards, therefore, need to be consulted with us and confirmed.
When an FPC board is connected, deflection in bending the FPC board may cause a solder crack.
In order to prevent it, it is suggested to attach a reinforcing plate that has 0.3 mm or more in
thickness to the connecting area on the FPC board.
It shall be prohibited to apply silkscreen printing to the area on the board where this connector is
mounted, because the connector running on the silkscreen printing may cause a mounting failure.
Although blisters may be formed due to the reflow heart, it will not interfere with the movability
of contacts, so there is no practical problem.
【コネクタ底面図例】
実装エリア(斜線部)
Mounted area (Shaded area)
ランドパターン(破線部)
Land pattern (Broken line)
固定金具・テール
Anchor plate tail
【Example of bottom views】
コンタクト・テール
Contact tail
ランドパターン(破線部)
Land pattern (Broken line)
本図は一例です。
本製品の実装エリア(投影エリア)につきましては図面を御確認下さい。
The figure above is an example.
Please refer to the drawing for the mounted area of this product.
6200 SERIES PRODUCT SPECIFICATION
No.201-03-6200-002
PAGE 7/9
© 2022 KYOCERA Corporation
106-03-004