ZXLD1366Q
AUTOMOTIVE COMPLIANT HIGH ACCURACY 1A, 60V LED DRIVER
Description
Pin Assignments
The ZXLD1366Q is
a continuous mode inductive step-down
(TOP VIEW)
converter, designed for driving single or multiple series connected
LEDs efficiently from a voltage source higher than the LED voltage.
The device operates from an input supply between 6V and 60V and
provides an externally adjustable output current of up to 1A.
1
2
VIN
LX
5
4
GND
The ZXLD1366Q uses a high-side output current sensing circuit
which uses an external resistor to set the nominal average output
current. The output current can be adjusted above or below the set
value by applying an external control signal to the 'ADJ' pin.
ISENSE
3
ADJ
TSOT25
(TOP VIEW)
Enhanced output current dimming resolution can be achieved by
VIN
6
LX
1
2
3
applying a PWM signal to the ‘ADJ’ pin.
5 GND
GND
ADJ
Soft-start can be forced using an external capacitor from the ADJ pin
to ground. Applying a voltage of 0.2V or lower to the ADJ pin turns
the output off and switches the device into a low current standby
state.
4
ISENSE
V-DFN3030-6
(TOP VIEW)
The ZXLD1366Q is qualified to AEC-Q100 Grade
Automotive Compliant supporting PPAPs.
1 and is
LX 1
VIN
8
7
6
5
Features
2
3
GND
GND
GND
GND
ISENSE
Typically Better than 0.8% Output Current Accuracy
Simple and With Low Part Count
4
ADJ
Single Pin On/Off and Brightness Control Using DC Voltage or
PWM
SO-8EP
PWM Resolution up to 1000:1
High Efficiency (up to 97%)
Typical Application Circuit
Switching Frequencies up to 1MHz
Wide Input Voltage Range: 6V to 60V
Inherent Open-Circuit LED Protection
Available in Thermally Enhanced Green Molding Packages
.
.
.
V-DFN3030-6
SO-8EP
JA = +44°C/W
JA = +45°C/W
JA = +82°C/W
TSOT25
Totally Lead-Free & Fully RoHS Compliant (Notes 1 & 2)
Halogen and Antimony Free. “Green” Device (Note 3)
Qualified to AEC-Q100 Standards for High Reliability
PPAP Capable (Note 4)
Applications
Automotive Lighting:
.
.
.
Internal Door Lights
Rear Fog Lamps
Position Lights
Notes:
1. No purposely added lead. Fully EU Directive 2002/95/EC (RoHS), 2011/65/EU (RoHS 2) & 2015/863/EU (RoHS 3) compliant.
2. See https://www.diodes.com/quality/lead-free/ for more information about Diodes Incorporated’s definitions of Halogen- and Antimony-free, "Green" and
Lead-free.
3. Halogen- and Antimony-free "Green” products are defined as those which contain <900ppm bromine, <900ppm chlorine (<1500ppm total Br + Cl) and
<1000ppm antimony compounds.
4. Automotive products are AEC-Q100 qualified and are PPAP capable. Refer to https://www.diodes.com/quality/.
1 of 32
www.diodes.com
April 2018
© Diodes Incorporated
ZXLD1366Q
Document number: DS37078 Rev. 2 - 2