5秒后页面跳转
VTO-8850R PDF预览

VTO-8850R

更新时间: 2024-01-04 18:05:44
品牌 Logo 应用领域
安捷伦 - AGILENT 振荡器
页数 文件大小 规格书
7页 919K
描述
Voltage Controlled Oscillator

VTO-8850R 技术参数

生命周期:TransferredReach Compliance Code:unknown
风险等级:5最大控制电压:30 V
最小控制电压:3 V安装特点:THROUGH HOLE MOUNT
偏移频率:50 kHz最大工作频率:9600 MHz
最小工作频率:8500 MHz最高工作温度:65 °C
最低工作温度:振荡器类型:VOLTAGE CONTROLLED OSCILLATOR
输出功率:10 dBm相位噪声:-82 dBc/Hz
物理尺寸:12.7mm x 4.572mm功率变化:1.5 dB
最大压摆率:100 mA标称供电电压:15 V
表面贴装:NOBase Number Matches:1

VTO-8850R 数据手册

 浏览型号VTO-8850R的Datasheet PDF文件第2页浏览型号VTO-8850R的Datasheet PDF文件第3页浏览型号VTO-8850R的Datasheet PDF文件第4页浏览型号VTO-8850R的Datasheet PDF文件第5页浏览型号VTO-8850R的Datasheet PDF文件第6页浏览型号VTO-8850R的Datasheet PDF文件第7页 
Varactor-Tuned Oscillators  
Technical Data  
VTO-8000 Series  
Pin Configuration  
Features  
variations in load impedance for  
TO-8V  
• 600 MHz to 10.5 GHz  
Coverage  
low frequency pulling, allows the  
oscillator to run lighty-loaded for  
low phase noise content and  
provides +10 dBm of minimum  
output power over the full tuning  
range. TheVTO-8000Series  
varactor-tuned oscillators are  
packaged in TO-8 transistor cans  
for simple installation in a  
GROUND  
3
1
+V  
• Fast Tuning  
TUNE  
RF  
OUT  
2
4
• +7to+13dBmOutput  
Power  
± 1.5 dB Output Flatness  
+DC  
VOLTAGE  
CASE GROUND  
• Hermetic Thin-film  
Construction  
conventional 50-ohm micro-  
stripline PC board. They are ideal  
for most compact, lightweight  
commercial and military equip-  
ment designs. Test fixturing is  
also available for lab bench test  
applications. See the “Test  
Fixtures for TO-8 Packages”  
section for additional information  
and outlines.  
Description  
HP VTO-8000 Series oscillators  
use a silicon transistor chip as a  
negative resistance oscillator. The  
oscillation frequency is deter-  
mined by a silicon abrupt varactor  
diode acting as a voltage-variable  
capacitor in a thin-film micro-  
stripline resonator. This provides  
extremely fast tuning speed,  
limited primarily by the internal  
impedance of the user-supplied  
voltage driver. Fast settling is  
another feature of the HP  
as possible to maximize V/T  
characteristics for excellent  
tuning speeds. Used in a phase  
locked loop PLL circuit, a VTO  
provides a receiver LO with  
stability equivalent to the refer-  
ence oscillator (usually crystal  
controlled), yet variable in  
discrete steps or continuously  
depending on the PLL  
Applications  
configuration.  
Frequency agile systems, such as  
digitally controlled receivers and  
active jamming transmitters often  
use externally linearized  
Another important aspect of VTOs  
used in an LO application is their  
power vs. frequency flatness  
(± 1.5 dB).Thisassuresthatoncea  
receiver mixer is biased for best  
dynamic range the local oscillator  
drive will remain constant  
throughout the tuning range  
without complex leveling  
VTO-8000Seriesoscillators.  
Typical settling times for the  
VTO-8090are<200 kHzwithinone  
microsecond while the VTO-8950  
settles to <2 MHz within two  
microseconds referenced to ten  
milliseconds.TheVTO-8850  
combines a bipolar transistor  
oscillator with a GaAs FET buffer  
stage. This GaAs FET buffer  
isolates the oscillator from  
varactor-tuned oscillators. HP  
oscillators are monotonic making  
external linearization easy using  
analog (opamp) or digital  
(EPROM) linearizing techniques.  
The HP VTO Series has been  
designed with a tuning input  
bypass capacitance which is  
sufficient to provide the neces-  
sary RF filtering action yet as low  
circuitry.  
9-23  
5964-9815E  

与VTO-8850R相关器件

型号 品牌 描述 获取价格 数据表
VTO-8950 AGILENT Varactor-Tuned Oscillators

获取价格

VTO-8950R AGILENT Voltage Controlled Oscillator

获取价格

VTO-8951 AGILENT Voltage Controlled Oscillator

获取价格

VTO-9000 AGILENT Hyperabrupt Varactor-Tuned Oscillators

获取价格

VTO-9032 AGILENT Hyperabrupt Varactor-Tuned Oscillators

获取价格

VTO-9032R AGILENT Voltage Controlled Oscillator

获取价格