TSOP132.., TSOP134.., TSOP136..
www.vishay.com
Vishay Semiconductors
IR Receiver Modules for Remote Control Systems
FEATURES
• Improved dark sensitivity
• Improved immunity against optical noise
• Improved immunity against Wi-Fi noise
• Low supply current
• Photo detector and preamplifier in one package
• Internal filter for PCM frequency
• Supply voltage: 2.5 V to 5.5 V
• Insensitive to supply voltage ripple and noise
• Material categorization: for definitions of
compliance please see www.vishay.com/doc?99912
23051
LINKS TO ADDITIONAL RESOURCES
MECHANICAL DATA
Pinning for TSOP13...:
1 = OUT, 2 = GND, 3 = VS
3
D
Product Page
3D Models
Calculators
Marking
Packages
ORDERING CODE
Holders
Bends and Cuts
TSOP13... - 1800 pieces in bags
DESCRIPTION
BLOCK DIAGRAM
The TSOP13... series devices are the latest generation
miniaturized IR receiver modules for infrared remote control
systems. This series provides improvements in sensitivity to
remote control signals in dark ambient as well as in
sensitivity in the presence of optical disturbances e.g. from
CFLs. The robustness against spurious pulses originating
from Wi-Fi signals has been enhanced.
16833-13
3
30 kΩ
1
Band
pass
Demo-
dulator
Input
AGC
The devices contain a PIN diode and a preamplifier
assembled on a lead frame. The epoxy package contains an
IR filter. The demodulated output signal can be directly
connected to a microprocessor for decoding.
2
PIN
Control circuit
The TSOP132.., TSOP134.., and TSOP136.. series devices
are designed to receive long burst codes (10 or more carrier
cycles per burst). The third digit designates the AGC level
(AGC2, AGC4, or AGC6) and the last two digits designate
the band-pass frequency (see table below). The higher the
AGC, the better noise is suppressed, but the lower the code
compatibility. AGC2 provides basic noise suppression,
AGC4 provides enhanced noise suppression and AGC6
provides maximized noise suppression. Generally, we
advise to select the highest AGC that satisfactorily receives
the desired remote code.
APPLICATION CIRCUIT
17170-11
R1
C1
Transmitter
with
TSALxxxx
IR receiver
VS
+ VS
μC
OUT
VO
GND
GND
These components have not been qualified to automotive
specifications.
R1 and C1 recommended to reduce supply ripple for VS < 2.8 V
Rev. 1.8, 30-Jul-2021
Document Number: 82806
1
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000