5秒后页面跳转
TPS61120PWG4 PDF预览

TPS61120PWG4

更新时间: 2024-02-12 23:40:43
品牌 Logo 应用领域
德州仪器 - TI 光电二极管
页数 文件大小 规格书
32页 1011K
描述
SYNCHRONOUS BOOST CONVERTER WITH 1.1A SWITCH AND INTEGRATED LDO

TPS61120PWG4 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Active零件包装代码:TSSOP
包装说明:TSSOP, TSSOP16,.25针数:16
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.39.00.01Factory Lead Time:1 week
风险等级:5.19模拟集成电路 - 其他类型:BATTERY CHARGE CONTROLLER
控制模式:CURRENT-MODE控制技术:PULSE WIDTH MODULATION
最大输入电压:5.5 V最小输入电压:1.8 V
标称输入电压:3.3 VJESD-30 代码:R-PDSO-G16
JESD-609代码:e4长度:5 mm
湿度敏感等级:1功能数量:1
端子数量:16最高工作温度:85 °C
最低工作温度:-40 °C最大输出电流:1.6 A
最大输出电压:5.5 V最小输出电压:2.5 V
封装主体材料:PLASTIC/EPOXY封装代码:TSSOP
封装等效代码:TSSOP16,.25封装形状:RECTANGULAR
封装形式:SMALL OUTLINE, THIN PROFILE, SHRINK PITCH峰值回流温度(摄氏度):260
认证状态:Not Qualified座面最大高度:1.2 mm
子类别:Switching Regulator or Controllers表面贴装:YES
切换器配置:BOOST最大切换频率:600 kHz
温度等级:INDUSTRIAL端子面层:Nickel/Palladium/Gold (Ni/Pd/Au)
端子形式:GULL WING端子节距:0.65 mm
端子位置:DUAL处于峰值回流温度下的最长时间:NOT SPECIFIED
宽度:4.4 mmBase Number Matches:1

TPS61120PWG4 数据手册

 浏览型号TPS61120PWG4的Datasheet PDF文件第2页浏览型号TPS61120PWG4的Datasheet PDF文件第3页浏览型号TPS61120PWG4的Datasheet PDF文件第4页浏览型号TPS61120PWG4的Datasheet PDF文件第5页浏览型号TPS61120PWG4的Datasheet PDF文件第6页浏览型号TPS61120PWG4的Datasheet PDF文件第7页 
TPS61120  
TPS61122, TPS61121  
A
c
t
m
u
a
x
l
S
4
i
,
z
1
e
5
A
m
c
m
t
u
x
a
l
6
S
i
z
m
e
(
4
,
1
5
m
m
m
)
(
5
,
0
,
4
m
)
www.ti.com  
SLVS427CJUNE 2002REVISED APRIL 2004  
SYNCHRONOUS BOOST CONVERTER WITH 1.1A SWITCH AND INTEGRATED LDO  
FEATURES  
DESCRIPTION  
Synchronous, 95% Efficient, Boost Converter  
With 500-mA Output Current From 1.8-V Input  
The TPS6112x devices provide a complete power  
supply solution for products powered by either a  
one-cell Li-Ion or Li-Polymer or a two up to 4 cells  
Alkaline, NiCd or NiMH batteries. The devices can  
generate two stable output voltages that are either  
adjusted by an external resistor divider or fixed  
internally on the chip. It also provides a simple  
solution for generating 3.3 V out of a one-cell Li-Ion  
or Li-Polymer battery at a maximum output current of  
at least 200 mA with supply voltages down to 1.8 V.  
The implemented boost converter is based on a fixed  
frequency, pulse-width-modulation (PWM) controller  
using a synchronous rectifier to obtain maximum  
efficiency. The maximum peak current in the boost  
switch is limited to a value of 1600 mA.  
Integrated 200-mA Reverse Voltage Protected  
LDO for DC/DC Output Voltage Post Regu-  
lation or Second Output Voltage  
40-µA (Typical) Total Device Quiescent Cur-  
rent  
Input Voltage Range: 1.8-V to 5.5-V  
Fixed and Adjustable Output Voltage Options  
up to 5.5-V  
Power Save Mode for Improved Efficiency at  
Low Output Power  
Low Battery Comparator  
Power Good Output  
The converter can be disabled to minimize battery  
drain. During shutdown, the load is completely dis-  
connected from the battery. A low-EMI mode is  
implemented to reduce ringing and in effect lower  
radiated electromagnetic energy when the converter  
enters the discontinuous conduction mode. A power  
good output at the boost stage simplifies control of  
any connected circuits like cascaded power supply  
stages or microprocessors.  
Low EMI-Converter (Integrated Antiringing  
Switch)  
Load Disconnect During Shutdown  
Overtemperature Protection  
Available in a Small 4mm x 4mm QFN-16 or in  
a TSSOP-16 Package  
APPLICATIONS  
The built-in LDO can be used for a second output  
voltage derived either from the boost output or  
directly from the battery. The LDO can be enabled  
separately i.e., using the power good of the boost  
stage. The device is packaged in a 16-pin QFN  
package measuring 4 mm x 4 mm (RSA) or in a  
16-pin TSSOP (PW) package.  
All Single Cell Li or Dual Cell Battery or USB  
Powered Products as MP-3 Player, PDAs, and  
Other Portable Equipment  
Dual Input or Dual Output Mode  
Simple Li-Ion to 3.3-V Conversion  
10 mH  
SWN  
VBAT  
LBI  
SWP  
10 mF  
Battery  
V
out1  
VOUT  
TPS61120  
100 mF  
FB  
ON  
ON  
OFF  
OFF  
SKIPEN  
EN  
PGOOD  
LBO  
Control  
Outputs  
Control  
Inputs  
LDOIN  
ON  
LDOEN  
V
out2  
OFF  
LDOOUT  
2.2 mF  
LDOSENSE  
GND PGND  
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas  
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
PRODUCTION DATA information is current as of publication date.  
Products conform to specifications per the terms of the Texas  
Instruments standard warranty. Production processing does not  
necessarily include testing of all parameters.  
Copyright © 2002–2004, Texas Instruments Incorporated  

TPS61120PWG4 替代型号

型号 品牌 替代类型 描述 数据表
TPS61120PWR TI

类似代替

SYNCHRONOUS BOOST CONVERTER WITH 1.1A SWITCH AND INTEGRATED LDO
TPS61120PWRG4 TI

类似代替

Adjustable, 95% Efficient Boost Converter with 200-mA LDO for 1-Cell LiIon or Dual-Cell Ap
TPS61120PW TI

类似代替

Adjustable, 95% Efficient Boost Converter with 200-mA LDO for 1-Cell LiIon or Dual-Cell Ap

与TPS61120PWG4相关器件

型号 品牌 获取价格 描述 数据表
TPS61120PWR TI

获取价格

SYNCHRONOUS BOOST CONVERTER WITH 1.1A SWITCH AND INTEGRATED LDO
TPS61120PWRG4 TI

获取价格

Adjustable, 95% Efficient Boost Converter with 200-mA LDO for 1-Cell LiIon or Dual-Cell Ap
TPS61120RSA TI

获取价格

IC 1.6 A BATTERY CHARGE CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PQCC16, 4 X 4 MM, PLASTIC,
TPS61120RSAR TI

获取价格

SYNCHRONOUS BOOST CONVERTER WITH 1.1A SWITCH AND INTEGRATED LDO
TPS61120RSARG4 TI

获取价格

SYNCHRONOUS BOOST CONVERTER WITH 1.1A SWITCH AND INTEGRATED LDO
TPS61121 TI

获取价格

SYNCHRONOUS BOOST CONVERTER WITH 1.1A SWITCH AND INTEGRATED LDO
TPS61121PW TI

获取价格

3.3-V 95% Efficient Boost Converter with 1.5-V 200-mA LDO for 1-Cell LiIon or Dual-Cell Ap
TPS61121PWG4 TI

获取价格

SYNCHRONOUS BOOST CONVERTER WITH 1.1A SWITCH AND INTEGRATED LDO
TPS61121PWR TI

获取价格

1.6A BATTERY CHARGE CONTROLLER, 600kHz SWITCHING FREQ-MAX, PDSO16, GREEN, PLASTIC, TSSOP-1
TPS61121PWRG4 TI

获取价格

IC 1.6 A BATTERY CHARGE CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO16, GREEN, PLASTIC, TS