TORX1701A(F)
(7)
(8)
Fixing fiber optic receiving module
Solder the fixed pin (pins 6 and 7) of fiber optic receiving module TORX1701A(F) to the printed circuit
board to fix the module to the board.
Solvent
When using solvent for flux removal, do not use a high acid or high alkali solvent. Be careful not to pour
solvent in to the optical connector ports. If solvent is inadvertently poured in to them, clean it off using
cotton tips.
(9) Protective cap
When the fiber optic receiving module TORX1701A(F) is not in use, attach the protective cap.
(10) Incidence of a photo flash
If strong light such as a photo flash is incident on an optical module, a transmission error may occur.
Be careful, to avoid such situations.
(11) Supply voltage
Use the supply voltage within the operating range (VCC =3.3 ± 0.3 V). Make sure that supply voltage does
not exceed the absolute maximum rating value of 4.5 V, even for an instant.
(12) Soldering condition
Solder at 260°C or less for no more than ten seconds.
(13) Precautions when disposing of devices and packing materials.
When disposing devices and packing materials, follow the procedures stipulated by local regulations in
order to protect the environment against contamination.
5
2016-05-19