TLC59116F
www.ti.com
SCLS714B –MARCH 2009–REVISED JULY 2011
16-CHANNEL FAST-MODE PLUS I2C BUS LED DRIVER
Check for Samples: TLC59116F
1
FEATURES
•
16 LED Drivers (Each Output Programmable at
•
•
Software Reset Feature (SWRST Call) Allows
OFF, ON, LED Brightness, and Group
Dimming/Blinking Mixed With Individual LED
Brightness)
the Device to be Reset Through the I2C Bus
Up to 14 Possible Hardware Adjustable
Individual I2C Bus Addresses Per Device so
That Each Device Can be Programmed
Output State Change Programmable on the
Acknowledge or the STOP Command to
Update Outputs Byte-by-Byte or All at the
Same Time (Default to 'Change on STOP').
•
•
16 Open-Drain Output Channels
256-Step (8-Bit) Linear Programmable
Brightness Per LED Output Varying From Fully
OFF (Default) to Maximum Brightness Using a
97-kHz PWM Signal
•
•
256-Step Group Brightness Control Allows
General Dimming (Using a 190-Hz PWM Signal
From Fully OFF to Maximum Brightness
(Default)
256-Step Group Blinking With Frequency
Programmable From 24 Hz to 10.73 s and Duty
Cycle from 0% to 99.6%
Four Hardware Address Pins Allow 14
TLC59116F Devices to be Connected to the
Same I2C Bus
Four Software-Programmable I2C Bus
Addresses (One LED Group Call Address and
Three LED Sub-Call Addresses) Allow Groups
of Devices to be Addressed Simultaneously in
Any Combination (For example, One Register
Used for 'All Call' So All the TLC59116Fs on
the I2C Bus Can be Addressed at the Same
Time and the Second register Used for three
different addresses so that 1/3 of all devices
on the bus can be addressed at the same time
in a group). Software Enable and Disable for
I2C Bus Address.
•
•
•
120-mA Maximum Output Current
17-V Maximum Output Voltage
25-MHz Internal Oscillator Requires No
External Components
1-MHz Fast-Mode Plus (FM+) Compatible I2C
Bus Interface With 30 mA High Drive
Capability on SDA Output for Driving High
Capacity Buses
Internal Power-On Reset
Noise Filter on SCL/SDA Inputs
No Glitch on Power Up
Active-Low Reset
Supports Hot Insertion
Low Standby Current
3.3-V or 5-V Supply Voltage
5.5-V Tolerant Inputs
28-Pin TSSOP (PW)
–40°C to 85°C Operation
•
•
•
•
•
•
•
•
•
•
•
•
•
•
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2009–2011, Texas Instruments Incorporated