TL507C, TL507l
ANALOG-TO-DIGITAL CONVERTER
SLAS041 – OCTOBER 1979 – REVISED OCTOBER 1988
P PACKAGE
(TOP VIEW)
Low Cost
7-Bit Resolution
Montonicity Over Entire A/D Conversion
Range
ENABLE
CLK
GND
OUTPUT
RESET
1
2
3
4
8
7
6
5
V
CC2
V
Ratiometric Conversion
CC1
ANALOG INPUT
Conversion Speed . . . Approximately 1 ms
Single-Supply Operation . . . Either
FUNCTION TABLE
Unregulated 8-V to 18-V (V
Regulated 3.5-V to 6-V (V
Input) or
Input)
CC2
CC1
ANALOG
INPUT CONDITION
ENABLE
OUTPUT
2
I L Technology
†
L
X
H
L
H
L
Power Consumption at 5 V . . . 25 mW Typ
V < 200 mV
I
H
H
H
Regulated 5.5-V Output (≤1 mA)
V
> V > 200 mV
I
ramp
V > V
I
ramp
description
†
Low level on enable also inhibits the reset function.
H = high level, L = low level, X = irrelevant
The TL507 is a low-cost single-slope analog-to-
digital converter designed to convert analog
A high level on RESET clears the counter to zero,
which sets the internal ramp to 0.75 V . Internal
CC
pulldown resistors keep RESET and ENABLE low
when not connected.
inputvoltages between 0.25 V
and 0.75 V
CC1
CC1
into a pulse-width-modulated output code. The
device contains a 7-bit synchronous counter, a
binary weighted resistor ladder network, an
operational amplifier, two comparators, a buffer
amplifier, an internal regulator, and necessary
2
logic circuitry. Integrated-injection logic (I L)
technology makes it possible to offer this complex
circuit at low cost in a small dual-in-line 8-pin
package.
In continuous operation, conversion speeds of up to 1000 conversions per second are possible. The TL507
requires external signals for CLK, RESET, and ENABLE. Versatility and simplicity of operation, coupled with low
cost, makes this converter especially useful for a wide variety of applications.
The TL507C is characterized for operation from 0°C to 70°C, and the TL507I is characterized for operation from
–40°C to 85°C.
Copyright 1988, Texas Instruments Incorporated
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
1
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265