5秒后页面跳转
STR485E PDF预览

STR485E

更新时间: 2023-12-20 18:46:30
品牌 Logo 应用领域
意法半导体 - STMICROELECTRONICS /
页数 文件大小 规格书
26页 1378K
描述
3.3V RS485,兼容1.8V I/O,可选择速度20Mbps或250kbps

STR485E 数据手册

 浏览型号STR485E的Datasheet PDF文件第1页浏览型号STR485E的Datasheet PDF文件第2页浏览型号STR485E的Datasheet PDF文件第3页浏览型号STR485E的Datasheet PDF文件第5页浏览型号STR485E的Datasheet PDF文件第6页浏览型号STR485E的Datasheet PDF文件第7页 
STR485E  
Truth tables  
2
Truth tables  
The STR485E is a half-duplex differential driver/receiver compliant to the RS485 communication standard (ISO-  
IEC 8482). This product is perfectly adapted for low voltage application running with a low power supplies VL,  
generally set to 1.8 V and VCC set to 3.3 V.  
These voltages confer a low power consumption to the product.  
SLR is the data rate selection, this pin could be let floating but it is not recommended; in that case the high speed  
rate is automatically selected.  
The SLR pin must be connected to the ground to provide a high speed communication up to 20 Mbps.  
When this pin is connected to VL power supply, the data rate is limited to 250 kbps more adapted for very long  
distance data transmission.  
Figure 4. Block diagram  
The product is perfectly adapted to run with 128 devices on the same bus thanks to the internal output resistance  
that is over 48 kΩ up to 125 °C; this resistance follows the RS485 condition that requests a minimum of 12 kΩ for  
16 unit loads (UL).  
The STR485E has internal protection against ESD that protect each device driver output and receiver input. The  
limits have been tested up ±4 kV electrostatic discharge (HBM) and ± 8 kV contact discharge and ± 16 kV air  
discharge shocks without latch-up.  
Another external protections can be used to increase the communication robustness against different perturbation  
that can be seen on the application.  
The power supplies must be well-decoupled by a minimal capacitor of 0.1 µF as closed as possible to the device  
power supply input. Moreover, the capacitor should be higher on the application with a minimum of 1 µF around  
the device.  
The device operating range is set from VL = 1.65 V to 3.6 V and for Vcc = 3.0 V to 3.6 V. In any case VCC must  
be higher or equal than VL.  
The applications should respect this voltage constraints to let the application communication device run to the  
best conditions.  
DS13051 - Rev 4  
page 4/26  
 
 

与STR485E相关器件

型号 品牌 描述 获取价格 数据表
STR4A100 SANKEN Off-Line PWM Controllers with Integrated Power MOSFET

获取价格

STR4A162D SANKEN Switching Controller

获取价格

STR4A162S SANKEN Switching Controller

获取价格

STR4A164D SANKEN Off-Line PWM Controllers with Integrated Power MOSFET

获取价格

STR4A164HD SANKEN Switching Controller

获取价格

STR4A60 SEMIWELL Bi-Directional Triode Thyristor

获取价格