5秒后页面跳转
SM5852-003-A-5-N PDF预览

SM5852-003-A-5-N

更新时间: 2022-12-18 02:56:42
品牌 Logo 应用领域
其他 - ETC 传感器压力传感器
页数 文件大小 规格书
4页 216K
描述
Amplified Pressure Sensor

SM5852-003-A-5-N 数据手册

 浏览型号SM5852-003-A-5-N的Datasheet PDF文件第1页浏览型号SM5852-003-A-5-N的Datasheet PDF文件第3页浏览型号SM5852-003-A-5-N的Datasheet PDF文件第4页 
SM5812/SM5852  
THEORY OF OPERATION  
The operation of the signal processor is  
depicted in the block diagram below. The  
external pressure sensor is a piezoresistive  
bridge. This transduces the applied pressure  
into an electronic signal, which is then inputted  
into the integrating amplifier of the ASIC.  
coefficients are available for correcting  
pressure and temperature non-linearity. The  
unique coefficients are determined during a  
calibration process performed at the factory.  
Factory calibration is the last step performed  
which means the effect of the package on  
the pressure signal will also be taken into  
account. This provides a great advantage  
over conventional laser-trimming  
During the amplification step an offset  
correction factor is added in order to allow  
maximum gain for a given pressure while  
minimizing the offset error.  
approaches.  
The DSP outputs a corrected digital word,  
which travels to a 12-bit digital to analog  
converter (DAC) to provide a calibrated  
analog output. In addition to the analog  
output, the corrected pressure signal is  
accessible through an I2C digital interface.  
The signal is then passed to an 11-bit analog  
to digital converter (ADC). The ADC samples  
the signal multiple times and uses the sum of  
those samples as a 13-bit word.  
A digital signal processor (DSP) is then used  
to correct and calibrate the pressure signal.  
The DSP provides multi-order correction of  
both pressure and temperature non-linearity  
through the use of factory-programmed  
coefficients. A combined total of twenty  
See SMI application note AN05-001 for a  
detailed description of how to read out the  
digital corrected pressure signal using the  
I2C bus interface.  
SMI Multi-Order Pressure and  
+ 5 VDC  
Temperature Correction ASIC  
+ 5 VDC  
Band-gap  
External  
Piezoresistive  
V
Temp  
Bridge  
DSP  
(multi-order  
correction of  
pressure and  
temperature  
non-  
12-bit  
Sigma-  
Switched  
MUX  
11-bit ADC  
Capacitor  
Delta DAC  
Ground  
Integrateing  
Amplifier  
linearities)  
Analog  
Output  
Buffer  
Analog  
Output  
Power-On  
Timing  
Reset  
EEPROM  
Array  
Control  
Digital Timing  
and Control  
Management  
2
SDA  
SCL  
2 MHz  
I C Digital  
Oscillator  
Interface  
Analog Component  
Digital Component  
Ground  
Rev 1.4 6_05  
2005 SMI  
Silicon Microstructures, Inc. 1701 McCarthy Blvd. Milpitas, CA 95035 USA  
Tel: 408-577-0100 Fax: 408-577-0123 Sales@si-micro.com www.si-micro.com  

与SM5852-003-A-5-N相关器件

型号 品牌 描述 获取价格 数据表
SM5852-003-D-3-L ETC Amplified Pressure Sensor

获取价格

SM5852-003-D-3-N ETC Amplified Pressure Sensor

获取价格

SM5852-003-D-5-L ETC Amplified Pressure Sensor

获取价格

SM5852-003-D-5-N ETC Amplified Pressure Sensor

获取价格

SM5852-003-G-3-L ETC Amplified Pressure Sensor

获取价格

SM5852-003-G-3-N ETC Amplified Pressure Sensor

获取价格