PRELIMINARY
FEBRUARY 2000
SC14425
Complete Baseband processor for DECT Base Stations
with Caller-id and Handsfree
General Description
n Embedded flexible dedicated DSP executing Caller-id
The SC14425SC14425 is a 3.3 Volt CMOS IC optimized
to handle all the audio, signal and data processing needed
within a DECT base station. An ADPCM transcoder, a
very low power 14 bit Codec and Analog Frontend are in-
tegrated. Direct connections towards analog or ISDN line
interface.
(CID), Caller-id on Call Waiting (CIDCW) and hands-
free, two echo cancellers, two echo suppressors, ex-
tended DTMF detection, DTMF generation, sidetone
and artificial echo loss.
n Two full duplex 32 kbits/sec ADPCM transcoder.
n On-chip Dedicated Instruction Processor (DiP) for all
TDMA based events, which supports 1.152MHz,
0.576MHz and 0.288MHz data rates.
The SC14425 has an on-chip dedicated flexible DSP op-
timized for telecom applications caller-id, handsfree and
allows easy connection to digital telephone answering
machine devices.
n Protected and unprotected full and double slot B-fields
n Standard DECT encryption with different keys for
different MAC-connections.
The SC14425 is designed to be compatible with many
radio interfaces. A dedicated TDMA controller handles all
physical layer slot formats and radio control. The integrat-
ed National Semiconductor’s standard CR16B processor
core takes care of all the higher protocol stack. Program-
mable I/O ports can be configured as chip selects for I/O
expanders, Serial Flashes, interrupt source or I/O. A dig-
ital serial interface can be configured to interface to indus-
try-standardcodecs and ISDN devices withm-Law, a-Law,
linear or transparent data formats.
n At least 6 MAC connections can be handled simultane-
ously.
n Flexible three wire interface to radio front synthesizer.
n One 14-bit linear CODEC with programmable gain
n Peak hold ADC for RSSI measurement
n Two input 8 bit successive approximation ADC.
n Three general purpose I/O ports with programmable in-
terrupts
n Full duplex UART, SPITM and MICROWIRETM interface.
n Flexible 8 kHz synchronous Serial interface to external
codecs and ISDN interface circuits.
n Two general purpose timers and watch dog timer.
n Programmable chip selects to 8 bit wide ROM, SRAM
NAND Flash Memory and I/O expanders.
Features
n Integrated DECT base band transceiver optimized for
GAP base stations according to ETS 300 175-2,3 & 8.
n 2.7 to 3.3 Volt operating voltage.
n Embedded 16 bit CompactRISCTM CR16B Microproc-
essor with In System Emulation (ISE) mode.
n On-chip 6kByte Data Memory.
n Two Capture timers for frequency measurement for
e.g. metering, ringing and call progress tone detection.
n 100 pin TQFP-100 package.
Note 1: CompactRISCTM is a trademark of National Semiconductor Cor-
poration,SPITM is a trademark of Motorola.
________________________________________________________________________________________________
System Diagram
ISDN or
Data
ISDN
sc14404
sc14404
Interface
sc14425
PSTN1
PSTN2
PSTN
Interface
CID
Handsfree
PSTN
Interface
sc14404
sc14404
sc14404
Copyright 2000 National Semiconductor Corp.
1
www.national.com