PRELIMINARY
FEBRUARY 2000
SC14404
Complete Baseband Processor for DECT Handsets
General Description
n 3V upto 5.0V battery monitor input.
n Advanced battery management unit
n Very low power in active and paging mode.
n Embedded 16 bit CompactRISCTM Micro Controller.
(CR16B) with programmable clock speeds.
n 4k byte memory mapped Flash
n 320 kbyte Flash or factory programmed ROM FLASH.
n ACCESSBUSTM or MICROWIRETM interfaces
n 5,5 kilobyte on-chip Data Memory.
The SC14404 is a CMOS chip optimized to handle all the
audio, signal and data processing needed within a DECT
handset. An ADPCM transcoder, a very low power CO-
DEC and Analog Frontend is integrated. Direct connec-
tions towards microphone and a (dynamical) loudspeaker
are provided. Duplex quality handsfree operation is inte-
grated.
The SC14404 is designed to fit to any radio design.
n One full duplex ADPCM transcoder.
n On-chip 14-bit linear CODEC.
n 14 upto 44 dB gain differential microphone input buffer.
n 100 W loudspeaker driver.
n Software controlled gain on audio input and output.
n Peak hold ADC for RSSI measurement.
n Five general purpose inputs can be multiplexed on an
8 bit ADC with selectable ranges.
A dedicated TDMA controller handles all physical layer
slot formats and radio control.
National Semiconductors standard CompactRISCTM
CR16B 16 bit microcontroller takes care of all the higher
protocol stack. 4kilobyteFlash is integrated for parameter
and number storage.
n On-chip dedicated TDMA instruction co-processor
which supports 1.152 MHz, 0.576 MHz and 0.288 MHz
bit rates.
Features
n Integrated DECT Baseband transceiver optimized for
GAP handsets according to ETS 300 175-2, 175-3 &
175-8.
n Two on board low drop voltage regulators with 2.85V
and 3.0- 3.8V (with external resistors the voltage can be
determined) output.
n Seven programmable control signals for radio front
end.
n Full and double slot, protected and unprotected B-
fields.
n Duplex quality handsfree operation.
n Tone generator. Tones consisting of 3 frequencies can
be programmed
n 2V upto 3.6V battery input with onboard step up con-
verter.
n Linear PCM interface for external codec.
________________________________________________________________________________________________
System Diagram
Note: ACCESSBUSTM, MICROWIRETM and CompactRISCTM are trade-
marks of National Semiconductor Corporation.
Copyright 2000 National Semiconductor Corp.
1
www.national.com